C971U472MZWDAA7317 Datasheet, PDF (14/16 Pages) Kemet Corporation – Safety Standard Recognized, 900 Series, Encapsulated, AC Type, X1 440 VAC/Y2 300 VAC (Industrial Grade)

Radial Leaded Ceramic Disc Capacitors
Safety Standard Recognized, 900 Series, Encapsulated, AC Type, X1 440 VAC/Y2 300 VAC (Industrial Grade)
Table 3 – Ammo Pack Taping Specifications cont'd
Lead Spacing
5 mm
7.5 mm
10 mm
Lead Style
Straight Preformed¹ Straight Preformed¹ Straight Preformed¹
Item
Symbol
Dimensions (mm)
Sprocket Hole Position
W₁
Height to Seating Plane²
(preformed leads¹)
H₀
9.0±0.5
N/A
18.0+2.0/−0
N/A
18.0+2.0/−0
N/A
18.0+2.0/−0
Height to Seating Plane²
(straight leads)
H
20.0+1.5/−1.0
N/A
20.0+1.5/−1.0
N/A
20.0+1.5/−1.0
N/A
Lead Protrusion
ℓ
2.0 maximum
Diameter of Sprocket Hole
D₀
Lead Diameter
φd
4.0±0.2
0.55±0.1
Carrier Tape Thickness
t₁
Total Thickness (Carrier Tape,
Hold-Down Tape and Lead)
t₂
Component Alignment (front/
∆h₁
back )
∆h₂
Cut Out Length
L
0.6±0.3
1.5 maximum
2.0 maximum
11.0 maximum
Hold-Down Tape Width
W₀
11.0 minimum
11.5 minimum
Hold-Down Tape Position
W₂
3.0 maximum
1.5±1.5
1 _{Prefromed (crimped) lead configurations include vertical kink, outside kink and inside kink. See "Lead Configurations" and "Ordering Information"}
sections of this document for further details.
2 _{Also referred to as "lead length" in this document.}
Application Notes:
Storage and Operating Conditions:
The insulating coating of these devices does not form an air and moisture-tight seal. Avoid exposure to moisture and do not
use or store these devices in a corrosive atmosphere, especially where chloride gas, sulfide gas, acid, alkali, salt, or the like
are present. Before cleaning, bonding or molding these devices, it is important to verify that your process does not affect
product quality and performance. KEMET recommends testing and evaluating the performance of a cleaned, bonded or
molded product prior to implementing and/or qualifying any of these processes. Store the capacitors where the temperature
and relative humidity do not exceed 40 degrees Centigrade and 70% respectively. For optimum solderability, capacitor stock
should be used promptly, preferably within 6 months of receipt.
Working Voltage:
Application voltage (Vp-p or Vo-p) must not exceed the voltage rating of the capacitor. Irregular voltages can be generated
for a transient period of time when voltage is initially applied and/or removed from a circuit. It is important to choose a
capacitor with a voltage rating greater than or equal to these irregular voltages.
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 • 864-963-6300 • www.kemet.com C1065_X1_440 VAC_Y2_300 VAC • 1/13/2017 14