N150 Datasheet, PDF (2/4 Pages) Baumer IVO GmbH & Co. KG – Spindle Position Displays

Spindle position displays
Through hollow shaft max. ø14 mm, manual format alignment
Display LCD two lines, interface RS485
Part number
N 150. 1
3
A 01
Through hollow shaft
A ø14 mm
Display
A Inclined
B Horizontal at front
Voltage supply
3 24 VDC
Connection
0 Connector output M8
1 Cable output M8
Interface
1 RS485
Accessories
Connectors and cables
Z 178.A01 Adaptor cable between cable connector M8
and female M16, 1 m
Z 178.AW1 Cable connector M8, 4-pin, less cable with
integrated terminating resistor 120 Ω
Z 178.B01 Female connector M8, 4-pin, less cable
Z 178.D05 Data and supply cable M8, Master to N 150
and N 155, 5 m
Z 178.S01 Cable connector M8, 4-pin, less cable
Z 178.V01 Coupling cable with M8 - M8, 1 m cable
Z 178.V03 Coupling cable with M8 - M8, 3 m cable
Z 178.V05 Coupling cable with M8 - M8, 5 m cable
Z 178.V10 Coupling cable with M8 - M8, 10 m cable
Z 178.050 Data and supply cable, ø5 mm,
4 cores, shielded, on 50 m drum
N 150
Description
N 150 spindle position display supports the editing engineer
in manual spindle positioning. The principal benefits of the
new electronic spindle position display are saving time in
machine setup and editing as well as eliminating errors
when aligning formats to new position values. The absolute
measuring system captures any change in position even
in powerless state. The backlit LCD display provides the
editing engineer with all necessary information for efficient
editing of new spindle positions. The two-line display shows
both current value and target. A little arrow signalizes the
editing engineer the direction the spindle must be turned to
get to the new position.
RS485 serial interface enables network of maximum 32
spindle position displays to PC or PLC.
For complete solutions also memory controllers serving as
decentralized operating and memory terminals are avail-
able. Up to 100 format profiles can be stored by teach-in.
Upon request the desired profile is recalled upon press-
ing a button and and retransmitted to every spindle position
display and shown as target.
2
www.baumer.com/motion