N150 Datasheet, PDF (1/4 Pages) Baumer IVO GmbH & Co. KG – Spindle Position Displays

Spindle position displays
Through hollow shaft max. ø14 mm, manual format alignment
Display LCD two lines, interface RS485
N 150
Features
–– Manual format alignment
–– Through hollow shaft max. ø14 mm
–– Resolution: 1440 steps/revolution ±4096 revolutions
–– Display: LCD backlit, two lines
–– Absolute multiturn measuring system
–– Actual value and target display
–– Interface RS485
N 150 with connector output
Technical data - electrical ratings
Voltage supply
Current consumption
Display
Measuring principle
Measuring range
Steps per turn
Number of turns
Spindle pitch
Interface
Data memory
Programmable
parameters
Standard
DIN EN 61010‑1
Emitted interference
Interference immunity
Approval
24 VDC ±10 %
≤30 mA
LCD, 7-segment display,
2-lines, backlit
Absolute multiturn measuring
system
-99.99...+999.99 mm
-9.999...+99.999 inch
1440
4096 / 12 bit
≤14 mm
RS485 (ASCII protocol)
Parameter buffer: EEPROM
Current value buffer: >10 years
by integrated 3 V lithium battery
Display position horizontal/
vertical
Measuring unit mm/inch
Spindle pitch
Counting direction
Spindle tolerance
Positioning direction
Direction arrows
Tolerance window
Round up/down
Protection class II
Overvoltage category II
Pollution degree 2
DIN EN 61000-6-3
DIN EN 61000-6-2
UL approval / E63076
Technical data - mechanical design
Shaft type
Operating speed
Protection DIN EN 60529
Operating temperature
Storage temperature
Relative humidity
Torque support
Connection
Housing type
Dimensions
Mounting
Weight approx.
Material
ø14 mm (through hollow shaft)
≤600 rpm (short-term)
IP 65
-10...+50 °C
-20...+70 °C
80 % non-condensing
Torque pin provided at housing
- Male/female connector M8,
4-pin
- Cable output (30/15 cm) with
male/female connector M8,
4-pin
Surface-mount with hollow shaft
37 x 75 x 45 mm
Surface-mount with hollow shaft
120 g
Polyamide black, UL 94V-0
1
www.baumer.com/motion