N140 Datasheet, PDF (2/4 Pages) Baumer IVO GmbH & Co. KG – Spindle Position Displays

Spindle Position Displays
Hollow shaft max. ø25 mm, manual format alignment
Display LCD two lines, interface RS485
N 140
Part number
N 140. 1 0 3 A
01
Hollow shaft
A Hollow shaft ø25 mm
B Hollow shaft ø20 mm
Display
A Inclined
Voltage supply
3 24 VDC
E-connection
0 Cable output with M16 connector
Interface
1 RS485
Description
N 140 spindle position display supports the editing engineer
in manual spindle positioning operations. The principal ben-
efits of the new electronic spindle position display is saving
time in machine setup and editing as well as elimination of
errors when aligning formats to new position values. The
absolute measuring system captures any change in position
even in powerless state. The backlit LCD display provides
the editing engineer with all necessary information for ef-
ficient editing of new spindle positions. The two-line display
shows both current value and target. A little arrow signalizes
the editing engineer the direction the spindle must be turned
to get to the new position. RS485 serial interface enables
network of 32 spindle position displays with PC or PLC.
For complete solutions also memory controllers as de-
centralized operating and memory terminals are available.
Up to 100 format profiles can be stored by teach-in. Upon
request the desired profile is recalled and retransmitted
upon pressing a button to every spindle position and shown
as target.
Accessories
Connectors and cables (page %S)
Z 165.B01 Mating connector M16, 5-pin, less cable
Z 165.AW1 Cable connector M16, 5-pin, less cable with
integrated terminating resistor 120 Ω
Z 165.D05 Data and supply cable M16, Master to N 140,
N 141 and N 142, 5 m
Z 165.S01 Cable connector M16, 5-pin, less cable
Z 165.V01 Coupling cable between M16 and M16, 1 m
2
www.baumerivo.com