N140 Datasheet, PDF (1/4 Pages) Baumer IVO GmbH & Co. KG – Spindle Position Displays

Spindle Position Displays
Hollow shaft max. ø25 mm, manual format alignment
Display LCD two lines, interface RS485
N 140
Features
–– Electronic spindle position display
–– Absolute multiturn measuring system
–– Display: LCD backlit, two lines
–– Actual value and target display
–– Hollow shaft ø20 mm / ø25 mm
–– Interface RS485
–– Resolution: 2304 steps/revolution ±4096 revolutions
N 140 with cable output
Technical data - electrical ratings
Voltage supply
Current consumption
Display
Measuring principle
Measuring range
Steps per turn
Number of turns
Spindle pitch
Interface
Data memory
Programmable
parameters
Standard
DIN EN 61010‑1
Emitted interference
Interference immunity
Approval
24 VDC ±10 %
≤30 mA
LCD, 7-segment display,
2-lines, backlit
Absolute multiturn measuring
system
-999,99...+9999,99 mm
-99.999...+999.999 inch
2304
4096 / 12 bit
≤23 mm
RS485 (ASCII protocol)
Parameter buffer: EEPROM
Current value buffer: >10 years
by integrated 3 V lithium battery
Display position horizontal/
vertical
Measuring unit mm/inch
Counting direction
Spindle pitch
Spindle tolerance
Positioning direction
Direction arrows
Tolerance window
Round up/down
Protection class II
Overvoltage category II
Pollution degree 2
DIN EN 61000-6-3
DIN EN 61000-6-2
UL/cUL
Technical data - mechanical design
Hollow shaft
Operating speed
Protection DIN EN 60529
Operating temperature
Storing temperature
Relative humidity
Torque support
E-connection
Housing type
Dimensions W x H x L
Mounting
Weight approx.
Material
ø20 mm, ø25 mm
≤600 rpm (short-term)
IP 65
-10...+50 °C
-20...+70 °C
80 % non-condensing
Torque pin provided at housing
- Cable output (30 cm) with
male/female connector M16,
5-pin
Surface-mount with hollow shaft
56 x 100 x 62.5 mm
Surface-mount with hollow shaft
200 g
Polycarbonate black, UL 94V-0
1
www.baumerivo.com