SSMB Datasheet, PDF (27/39 Pages) ITT Industries – RF Coaxial Connectors

RF Coaxial Connectors
BBAI-1040 SMZ Straight Connectors, Solder Contact, for Braided Cable
Assembly Instructions
FERRULE
REAR BODY ASSEMBLY
CONTACT
(REAR PORTION)
FRONT
INSULATOR
(PLUG ONLY)
1. Trim cable to dimensions shown being careful not to nick the braid or center conductor. Tin center
conductor, (DO NOT OVER TIN) then slip ferrule over cable.
2. Insert trimmed cable into back end of rear body. The tubular extension will slide under the braid.
The tinned end of the center conductor should project 0,75 (.030) beyond the face of the insulator.
Slip ferrule up to hex. Face of rear body and crimp in position using ITT Cannon crimp tool and
suitable die set (see table).
Cable
BT2001
BT2002
BT2003
BT3002
RG59B/U
RG62/U
RG140/U
RG179B/U
RG180/U
RG187A/U
RG195A/U
RD179
TZC75024
Die Size
4,52 (.178)
5,18 (.204)
6,81 (.268)
4,52 (.178)
6,48 (.255)
6,48 (.255)
6,48 (.255)
3,25 (.128)
4,52 (.178)
3,25 (.128)
4,52 (.178)
3,84 (.151)
4,52 (.178)
Assy Insts
3. Add 2,00 (.078) long slug of 24 SWG60/40 tin/lead solder to bore of contact. Assemble contact
onto center conductor with the shoulder of contact flush with insulator as shown. Heat to make
soldered connection.
4. Assemble front insulator over contact (jack front insulator is pre-assembled into front body at the
factory) then slip front body onto rear body and tighten with torque of 0,99 - 1,06 Nm
(140 - 150 in. ozs.)
Dimensions are shown in mm (inch)
Dimensions subject to change 131