IS61QDP2B42M18A Datasheet, PDF (4/33 Pages) Integrated Silicon Solution, Inc – 1Mx36 and 2Mx18 configuration available

IS61QDP2B42M18A/A1/A2
IS61QDP2B41M36A/A1/A2
SRAM Features description
Block Diagram
36 (18)
D (Data-In)
Data
Register
18 (19)
Address
Address
Register
18 (19)
R#
W#
BWx#
4 (2)
Control
Logic
72 (36) 72 (36)
Write
Driver
72 (36)
1M x 36
(2M x 18)
Memory Array
72 (36)
72 (36)
Output ^{144 (72)}
Register
36 (18)
36 (18)
Q (Data-out)
QVLD
2
CQ, CQ#
(Echo Clocks)
QVLD
2
CQ, CQ#
(Echo Clocks)
K
K#
Doff#
Clock
Generator
Select Output Control
Note: Numerical values in parentheses refer to the x18 device configuration.
Read Operations
The SRAM operates continuously in a burst-of-four mode. Read cycles are started by registering R# in active low state
at the rising edge of the K clock. R# can be activated every other cycle because two full cycles are required to
complete the burst of four in DDR mode. A set of free-running echo clocks, CQ and CQ#, are produced internally with
timings identical to the data-outs. The echo clocks can be used as data capture clocks by the receiver device.
The data corresponding to the first address is clocked two cycles later by the rising edge of the K clock. The data
corresponding to the second burst is clocked two and half cycles later by the following rising edge of the K# clock. The
third data-out is clocked by the subsequent rising edge of the K clock, and the fourth data-out is clocked by the
subsequent rising edge of the K# clock.
A NOP operation (R# is high) does not terminate the previous read.
Write Operations
Write operations can also be initiated at every other rising edge of the K clock whenever W# is low. The write address
is provided simultaneously. Again, the write always occurs in bursts of four.
The write data is provided in a ‘late write’ mode; that is, the data-in corresponding to the first address of the burst, is
presented one cycle later or at the rising edge of the following K clock. The data-in corresponding to the second write
burst address follows next, registered by the rising edge of K#. The third data-in is clocked by the subsequent rising
edge of the K clock, and the fourth data-in is clocked by the subsequent rising edge of the K# clock.
Integrated Silicon Solution, Inc.- www.issi.com
4
Rev. B
12/15/2014