SG-QFE-7006 Datasheet, PDF (2/3 Pages) Ironwood Electronics. – Compression plate distributes forces evenly

Recommended PCB Layout
Top View
Orientation Mark
1.25mm±0.13mm (x4)
3.1625mm
1.25mm±0.13mm (x4)
5.3625mm*
30.225mm±0.125mm (x4)
Socket size
5.08mm
*Note: QFP pattern is not symmetrical with
respect to the mounting holes.
4.7225mm
1.78mm
2.54mm
Ø 0.85mm±0.025mm (x2)
Non plated Alignment Hole
0.25mm(x144)
0.5mm
3.118mm
Target PCB Recommendations
Total thickness: 1.6mm min.
Plating: Gold or Solder finish
PCB Pad height: Same or higher than solder mask
17.5mm
21.4mm
23.18mm
27.725mm (x4)
Ø 1.61mm±0.05mm (x4)
Non plated Mounting Hole
NOTE: Steel backing plate may be required based on end user's application
Recommended PCB Layout Tolerances: ±0.025mm [±0.001”] unless stated otherwise.
SG-QFE-7006 Drawing
© 2010 IRONWOOD ELECTRONICS, INC.
11351 Rupp Dr. Ste 400 Burnsville, MN 55337
Tele: [phone]
www.ironwoodelectronics.com
Status: Released
Drawing: V. Panavala
File: SG-QFE-7006 Dwg
Scale: 3:1
Rev: B
Date: 10/8/10
Modified: 04/29/15, DH
PAGE 2 of 3