CG-QFN-7005 Datasheet, PDF (2/4 Pages) Ironwood Electronics. – Directly mounts to target PCB with hardware

Recommended PCB
Layout Top View
C*
Orientation Mark
1.25mm±0.125mm (x4)
1.25mm±0.125mm (x4)
*Note: QFN pattern is not symmetrical with
respect to the mounting holes. It is offset
0.25mm to the right of center.
e typ.
D thermal /GND pad
Ø 0.85mm±0.025mm (x2)
Non plated alignment hole
B
Z1
A1
2mm
3mm
(x N)x x y pads
Ø 1.75mm±0.05mm(x5)
Non plated mounting hole
Target PCB Recommendations
Total thickness: 1.6mm min.
Plating: Gold or Solder finish
PCB Pad height: Same or higher than solder mask
A2
Z2
9.725mm (x4)
12.225mm±0.125mm (x4)
Socket base 21.475mm
25.475mm Lid size
NOTE: Steel backing plate may be required based on end user's application
Recommended PCB Layout Tolerances: ±0.025mm unless stated otherwise.
All dimensions are in mm.
CG-QFN-7005 Drawing
© 2011 IRONWOOD ELECTRONICS, INC.
Tele: [phone]
www.ironwoodelectronics.com
Status: Released
Scale: -
Rev: B
Drawing: E Smolentseva
File: CG-QFN-7005 Dwg.mcd
Date: 2/24/11
Modified: 05/28/14, DH
PAGE 2 of 4