AUIRS20302S_15 Datasheet, PDF (6/28 Pages) International Rectifier – Pre-regulated Three Phase Gate Driver

AUIRS20302S
Static Electrical Characteristics
Unless otherwise noted, these specifications apply for an operating junction temperature range of -40°C ≤ Tj ≤ 125°C with bias conditions of
VBIAS (VPR,VBS 1,2,3) = 15V. The VIN , VTH and IN parameters are referenced to VSS and are applicable to all six channels (HS 1,2,3
and LS 1,2,3). The VO and IO parameters are referenced to COM and VS 1,2,3 and are applicable to the respective output leads: LO1,2,3
and HO1,2,3.
Symbol
Definition
Min Typ Max _Units Test Conditions
VIN,th+
VIN,th-
Input positive going threshold (Hin#, Lin#, EN, FRST)
Input negative going threshold (Hin#, Lin#, EN, FRST)
- 1.9 2.5
0,7 1
-
V
Iin+
Input bias current (Lin#, Hin#, EN, FRST)
Iin-
Input bias current (Lin#, Hin#, EN, FRST)
15 100 220
-1 0
1 ^µA
Vin=5V
Vin=0V
VPR,UVth+
VPR supply undervoltage positive going threshold (note 2) 6.4 7.2 8,2
VPR,UVth-
VPR supply undervoltage negative going threshold (note 2) 6 6.7 7.6
VPR,UVhys
VBS, UVth+
VPR supply undervoltage hysteresis (note 2)
VBS supply undervoltage positive going threshold
0.4 0.5 0.7
V
6.4 7.2 8,2
VBS, UVth-
VBS supply undervoltage negative going threshold
6 6.7 7.6
VBS, UVhys
VBS supply undervoltage hysteresis
0.4 0.5 0.7
I_LK
Offset supply leakage current
Iqbs
Quiescent VBS supply current
- 5 50
VB=VS=200V
20 45 120 ^µA
Iqpr
Quiescent VPR supply current
1 2,5 5 _mA VPR=14V
V_OH
V_OL
Io+
Io-
VCP
ICP+
ICP-
High level output voltage, VPR – VO, HO#
Low level output voltage, VO, HO#
Output high short circuit pulsed current, HO#,LO#
Output low short circuit pulsed current, HO#,LO#
Charge pump output voltage
Charge Pump source current
Charge Pump sink current
VPR=4V
VPR=8V
VPR=9V
VPR=14V
VPR=6V
VPR=14V
0,2 0.9 1.4
V
0,05 0.2 0.6
105 200 450 _mA
210 350 650 mA
5 6 7,5
10
13
13
15
15
17
V
13 15 17
100
200
200 400
500 1000
µA
- 5 10 _mA
Io =20mA
Vo =0V,
PW ≤10 µs
Vo =15V,
PW ≤10 µs
Rext=100kΩ
Vcl_Vcp
Vcp pin Active Clamp
17 18.6 21
Icp=10mA
VFLT
FLT low output voltage
-
- 0.8 _{V IFLT = 10mA}
Ican1
Ican0
Comparator input high bias current
Comparator input low bias current
- -7
Can=5V
-
-
7 ^µA
Can=0V
Voff
Comparator input offset
-33 - 33 _mV Vcap= 5V
Tfrst
Minimum FAULT RESET time
20 - - _us
Ton_EN
Minimum ENABLE time
20 - - _us
(note 2):. UVPR is latched; when VPR>UVPR, FAULT remains pulled down. This leads to have the FAULT active and latched at VPR ramp
up if no fault reset occurs.
6 www.irf.com © 2014 International Rectifier
Submit Datasheet Feedback
May 28, 2014