AUIPS1042G Datasheet, PDF (3/18 Pages) International Rectifier – SINGLE/DUAL CHANNEL INTELLIGENT POWER LOW SIDE SWITCH

AUIPS1041(L)(R) / AUIPS1042G
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. (Tj= -40°C..150°C,
Vcc=6..36V unless otherwise specified).
Symbol Parameter
Min. Max. Units
Vds
Maximum drain to source voltage
-0.3 36
V
Vds cont
Maximum continuous drain to source voltage
-
28
V
Vin
Maximum input voltage
-0.3
6
V
Isd cont.
Max diode continuous current (limited by thermal dissipation)

1.5
A
Maximum power dissipation (internally limited by thermal protection)
Pd
Rth=60°C/W AUIPS1041L 1” sqr. Footprint
2
W
Rth=100°C/W AUIPS1042G std. footprint
1.25
Tj max.
Max. storage & operating temperature junction temperature
-40 150
°C
Thermal Characteristics
Symbol Parameter
Typ.
Rth1
Thermal resistance junction to ambient AUIPS1041L SOT-223 std. footprint 100
Rth2
Thermal resistance junction to ambient AUIPS1041L SOT-223 1” sqr.
Footprint
60
Rth1
Thermal resistance junction to ambient AUIPS1041R D-Pak std. footprint
70
Rth2
Thermal resistance junction to case AUIPS1041R D-Pak
6
Rth1
Thermal resistance junction to ambient AUIPS1042G SO-8 std. Footprint
1 die active
100
Rth1
Thermal resistance junction to ambient AUIPS1042G SO-8 std. footprint
2 die active
130
Max.





Units
°C/W

Recommended Operating Conditions
These values are given for a quick design. For operation outside these conditions, please consult the application notes.
Symbol
Parameter
Min. Max. Units
VIH
High level input voltage
VIL
Low level input voltage
4.5 5.5
0
0.5
V
Continuous drain current, Tambient=85°C, Tj=125°C, Vin=5V
Rth=60°C/W AUIPS1041L 1” sqr. Footprint

1.95
Ids
Continuous drain current, Tambient=85°C, Tj=125°C, Vin=5V
Rth=50°C/W AUIPS1041R 1” sqr. Footprint
Continuous drain current, Tambient=85°C, Tj=125°C, Vin=5V
Rth=100°C/W AUIPS1042G 1” sqr. Footprint - 1 die active

2.2
A

1.5
Continuous drain current, Tambient=85°C, Tj=125°C, Vin=5V
Rth=130°C/W AUIPS1042G 1” sqr. Footprint - 2 die active
0.7
Rin
Recommended resistor in series with IN pin to generate a diagnostic
0.5
10
k
Max L
Max. recommended load inductance ( including line inductance ) (1)

20
µH
Max. F
Max. frequency
 2000 Hz
Max. t rise
Max. input rising time

1
µs
(1) Higher inductance is possible if maximum load current is limited - see figure 11
www.irf.com
3