ISL59115 Datasheet, PDF (9/10 Pages) Intersil Corporation – Triple Channel Video Driver with LPF

ISL59115
Power Dissipation
With the high output drive capability of the ISL59115, it is
possible to exceed the +125°C absolute maximum junction
temperature under certain load current conditions.
Therefore, it is important to calculate the maximum junction
temperature for an application to determine if load conditions
or package types need to be modified to assure operation of
the amplifier in a safe operating area.
The maximum power dissipation allowed in a package is
determined according to:
PD_MAX
=
T_{----J---M-----A----X-----–-----}T_{----A---M-----A----X--}
Θ_JA
Where:
T_JMAX = Maximum junction temperature
T_AMAX = Maximum ambient temperature
Θ_JA = Thermal resistance of the package
The maximum power dissipation actually produced by an IC
is the total quiescent supply current times the total power
supply voltage, plus the power in the IC due to the load, or:
for sourcing:
PD_MAX
=
V_S
×
I_S
M
A
X
+
(
V_S
–
V_O
U
T
)
×
-^V----^O----^U----^T--
R_L
Power Supply Bypassing Printed Circuit Board
Layout
As with any modern operational amplifier, a good printed
circuit board layout is necessary for optimum performance.
Lead lengths should be as short as possible. The power
supply pin must be well bypassed to reduce the risk of
oscillation. For normal single supply operation, a single
4.7µF tantalum capacitor in parallel with a 0.1µF ceramic
capacitor from V_S+ to GND will suffice.
Printed Circuit Board Layout
For good AC performance, parasitic capacitance should be
kept to minimum. Use of wire wound resistors should be
avoided because of their additional series inductance. Use
of sockets should also be avoided if possible. Sockets add
parasitic inductance and capacitance that can result in
compromised performance.
for sinking:
PD_MAX = V_S × I_SMAX + (V_OUT – V_S) × I_LOAD
Where:
V_S = Supply voltage
I_SMAX = Maximum quiescent supply current
V_OUT = Maximum output voltage of the application
R_LOAD = Load resistance tied to ground
I_LOAD = Load current
All Intersil U.S. products are manufactured, assembled and tested utilizing ISO9000 quality systems.
Intersil Corporation’s quality certifications can be viewed at www.intersil.com/design/quality
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without
notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and
reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result
from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
9
FN6185.2
September 21, 2006