ISL59111 Datasheet, PDF (9/10 Pages) Intersil Corporation – 8MHz Rail-to-Rail Composite Video Driver

ISL59111
Where:
V_S = Supply voltage
I_SMAX = Maximum quiescent supply current
V_OUT = Maximum output voltage of the application
R_LOAD = Load resistance tied to ground
I_LOAD = Load current
By setting the two P_DMAX equations equal to each other, we
can solve the output current and R_LOAD to avoid the device
overheat.
Power Supply Bypassing Printed Circuit Board
Layout
As with any modern operational amplifier, a good printed
circuit board layout is necessary for optimum performance.
Lead lengths should be as short as possible. The power
supply pin must be well bypassed to reduce the risk of
oscillation. For normal single supply operation, a single
4.7µF tantalum capacitor in parallel with a 0.1µF ceramic
capacitor from V_S+ to GND will suffice.
Printed Circuit Board Layout
For good AC performance, parasitic capacitance should be
kept to minimum. Use of wire wound resistors should be
avoided because of their additional series inductance. Use
of sockets should also be avoided if possible. Sockets add
parasitic inductance and capacitance that can result in
compromised performance.
9
FN6172.3
August 29, 2006