ISL1536_14 Datasheet, PDF (8/9 Pages) Intersil Corporation – Dual Channel Central Office ADSL2+ Line Driver

Revision History
DATE
REVISION
CHANGE
November 20, 2012
FN6508.4
Added Note 3 to “Ordering Information” on page 1.
Changed HBM from 3kV to 4kV in “Absolute Maximum Ratings” on page 3.
Changed MM from 300V to 250V in “Absolute Maximum Ratings” on page 3
Added Note 5 to “Electrical Specifications” table on page 4.
March 8, 2010 FN6508.3 On page 4, changed the “Maximum Operating Supply Voltage” TYP from ±12.6V to ±13.2V
February 8, 2010
May 29, 2009
On page 3 in the “Electrical Specifications” table, changed V_OUT-DIS Max spec from ±300mV to ±800mV
Added Revision History beginning from rev 3.
Changed the logic high level (VIH) on page 3 from Min 2.0V to Min 2.2V, which is consistent with the intended
applications (AFE output logic high levels are typically at 3.3V with 2.4V minimum) while providing added margin
to internal threshold variation.
On page 1 in the first paragraph, changed: "This device features a high drive capability of 400mA while
consuming only 3mA..." to "This device features a high drive capability of 400mA while consuming only 4mA...".
Added Theta JA and applicable note to “Thermal Information” on page 3.
Removed VS, Supply Voltage row in spec table. Added Maximum and Minimum Operating Supply Voltages
(V_S(MAX) and V_S(MIN)) with typical specs of ±12.6V and ±7.5V to “SUPPLY CHARACTERISTICS” on page 4.
Added “DISAB = DISCD = 0” to “Electrical Specifications” table common conditions.
For additional products, see www.intersil.com/en/products.html
Intersil products are manufactured, assembled and tested utilizing ISO9000 quality systems as noted
in the quality certifications found at www.intersil.com/en/support/qualandreliability.html
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at
any time without notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by
Intersil is believed to be accurate and reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements
of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent
rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
8
FN6508.4
February 15, 2013