ISL54209 Datasheet, PDF (7/19 Pages) Intersil Corporation – MP3/USB 2.0 High Speed Switch with Negative Signal Handling and Low Power Shutdown

ISL54209
Electrical Specifications - 2.7V to 3.6V Supply Test Conditions: V_DD = +3.0V, GND = 0V, V_INH = V_CTRLH = 1.4V,
V_INL = V_CTRLL = 0.5V, (Note 11), Unless Otherwise Specified. Boldface limits apply over the operating temperature range,
-40°C to +85°C. (Continued)
PARAMETER
TEST CONDITIONS
TEMP
MIN
MAX
(°C) (Notes 12, 13) TYP (Notes 12, 13) UNITS
Input Current, I_INL,
I_CTRLL
V_DD = 3.6V, IN = 0V, CTRL = 0V
Full
-50
20
50
nA
Input Current, I_INH
V_DD = 3.6V, IN = 3.6, CTRL = 0V
Full
-2
0.9
2
µA
Input Current, I_CTRLH V_DD = 3.6V, IN = 0V, CTRL = 3.6V
Full
-2
0.9
2
µA
CTRL Pull-Down Resistor, V_DD = 3.6V, IN = 0V, CTRL = 3.6V; measure Full
-
4
-
MΩ
R_CTRL
current through the internal pull-down
resistor and calculate resistance value.
IN Pull-Down Resistor, V_DD = 3.6V, IN = 3.6V, CTRL = 3.6V;
Full
-
4
-
MΩ
R_IN
measure current through the internal
pull-down resistor and calculate resistance
value.
NOTES:
11. V_LOGIC = Input voltage to perform proper function.
12. The algebraic convention, whereby the most negative value is a minimum and the most positive a maximum, is used in this
data sheet.
13. Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established
by characterization and are not production tested.
14. Flatness is defined as the difference between maximum and minimum value of ON-resistance over the specified analog signal
range.
15. Limits established by characterization and are not production tested.
16. r_ON matching between channels is calculated by subtracting the channel with the highest max r_ON value from the channel
with lowest max r_ON value, between L and R or between D+ and D-.
7
FN6627.4
June 10, 2010