ISL36356A-APDK Datasheet, PDF (7/7 Pages) Intersil Corporation – PRISM 11Mbps Wireless Local Area Network Access Point

ISL36356A-APDK
Operation of this equipment in a residential area may cause
harmful interference in which case the user will be required
to correct the interference at his own expense.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
FCC Guidelines for Human Exposure
The EIRP was measured for the lower, middle and highest
frequencies used by the transmitter. The results in Table 5
are based on a safe distance between antenna and
operator of eight inches.The equipment therefore fulfills the
requirements on power density for general population /
uncontrolled exposure of 1.0mW/cm² and therefore
complies with the requirements of FCC Part 15.247 (b) (4)
and FCC OET Bulletin 65 including supplements A, B and C.
TABLE 5. POWER DENSITY CALCULATION
Ch.1
Ch.6
Ch.11
Measured EIRP
63.8
(mW)
66.2
69.3
Calculated Power
Density (mW/cm2)
0.051
0.053
0.055
WARNING: Any changes or modifications of equipment not expressly
approved by Intersil could void the user’s authority to operate the equipment.
Caution:To comply with FCC RF exposure limits, a separation distance of at
least 20cm must be maintained between the antenna’s of this device and all
persons.
All Intersil U.S. products are manufactured, assembled and tested utilizing ISO9000 quality systems.
Intersil Corporation’s quality certifications can be viewed at www.intersil.com/design/quality
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without
notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and
reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result
from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
7