ISL36356A-APDK Datasheet, PDF (2/7 Pages) Intersil Corporation – PRISM 11Mbps Wireless Local Area Network Access Point

ISL36356A-APDK
Absolute Maximum Ratings
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 7.5V (Max)
Storage Temperature (Note 1) . . . . . . . . . . . . . . . . . . -20^oC to 85^oC
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . .0^oC ≤ T_A ≤ 50^oC
Supply Voltage Range . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5V to 5.5V
Caution: These are the absolute maximum ratings for the product. Exceeding these limits could cause permanent damage to the AP.
NOTE:
1. All temperature references refer to ambient conditions.
Electrical Specifications Test Conditions: Supply Voltage (V_CC) = 5V, Ambient Temperature (T_A) = 25^oC,
Unless Otherwise Specified
PARAMETER
SYMBOL
TEST CONDITIONS
MIN TYP
MAX
UNITS
CURRENT CONSUMPTION
Initialization Current
Continuous Transmit Mode
Continuous Receive Mode
RF SYSTEM SPECIFICATIONS
I_CC
I_CC
I_CC
Receiving Valid Packets
-
517
-
mA
-
670
-
mA
-
516
-
mA
Transmitter Power Output
Receive Sensitivity
P_out
RX_S
1Mbps, BER 8 E-5
14.8 16.2
17.0
-
-93
-
(Note 2)
dBm
dBm
2Mbps,BER 8 E-5
-
-89
-
(Note 2)
dBm
5.5Mbps,BER 8 E-5
-
-87
-
(Note 2)
dBm
11Mbps, BER 8 E-5
-
-83
-
(Note 2)
dBm
Multipath Delay Spread using Naftali
model
T_DELAY
2Mbps,BER 8 E-5
5.5Mbps, BER 8 E-5
-
>290
-
ns
-
200
-
ns
11Mbps, BER 8 E-5
-
105
-
ns
Maximum Receive Level
RX_MAX BER 8 E-5
-3
>2
-
dBm
Third Order Intercept Point (Input)
IIP3_90 -90 dBm input
-
-3
-
dBm
IIP3_25 -25 dBm input
-
+20
-
dBm
Carrier Suppression
TX_sup Test Mode
-
43
-
dB
Image Rejection
IR
BER 8E-5
-
65
-
dB
IF Rejection
IFR
BER 8E-5
60
66
-
dB
Adjacent Channel Rejection (Note 3)
ACR
BER 8E-5
-
35
-
dB
Data Rate (Physical Layer)
Rate
- 1, 2, 5.5
-
and 11
Mbps
NOTES:
2. Measurements done on antenna port 1. Antenna port 2, 1 to 2 dB better performance.
3. The adjacent channel measurement is carried out on two antennas separated by 25MHz (five channels). The -70dBm desired signal and variable
strength jammer are both 11Mbps DSSS data transmissions. The jammer is a continuous waveform with -40dBc first sidelobes.
2