ISL33334E Datasheet, PDF (6/23 Pages) Intersil Corporation – Operates from a single 3.3V supply

ISL33334E, ISL33337E
Absolute Maximum Ratings (T_A = +25°C)
V_CC to Ground . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7V
Input Voltages
All Except A,B, RxIN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to 7V
Input/Output Voltages
A, B, RxIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -25V to +25V
Y, Z, TxOUT (Note 5). . . . . . . . . . . . . . . . . . . . . . . . . . . . . -12.5V to +12.5V
RO, RxOUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to (V_CC + 0.5V)
Output Short-circuit Duration
Y, Z, TxOUT, RxOUT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Indefinite
ESD Rating . . . . . . . . . . . . . . . . . . . . . . . See Specification Table on page 7
Latch-up (per JESD78D, Level 2, Class A) . . . . . . . . . . . . . . . . . . . . . +85°C
Thermal Information
Thermal Resistance (Typical)
_JA (°C/W) _JC (°C/W)
28 Ld SSOP Package (Notes 7, 9) . . . . . . . . 60
36
40 Ld QFN Package (Notes 6, 8) . . . . . . . . . 32
2.5
Maximum Junction Temperature (Plastic Package) . . . . . . . . . . . . +150°C
Maximum Storage Temperature Range . . . . . . . . . . . . . . -65°C to +150°C
Pb-free Reflow Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .see TB493
Recommended Operating Conditions
Supply Voltage (V_CC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.3V
Temperature Range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40°C to +85°C
RS-485 Tx Load . . . . . . . . . . . . . . . . . . . . . . One or two 120Ω Terminations
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product
reliability and result in failures not covered by warranty.
NOTES:
5. One output at a time, I_OUT ≤100mA for ≤10 mins.
6. _JA is measured in free air with the component mounted on a high effective thermal conductivity test board with “direct attach” features. See Tech
Brief TB379.
7. _JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
8. For _JC, the “case temp” location is the center of the exposed metal pad on the package underside.
9. For _JC, the “case temp” location is taken at the package top center.
Electrical Specifications Test Conditions: V_CC = 3.15V to 3.45V, C₁ - C₄ = 0.1µF; unless otherwise specified. Typicals are at V_CC = 3.3V,
T_A = +25°C (Note 10). Boldface limits apply across the operating temperature range, -40°C to +85°C.
PARAMETER
SYMBOL
TEST CONDITIONS
TEMP MIN
MAX
(°C) (Note 14) TYP (Note 14) UNIT
DC CHARACTERISTICS - RS-485 DRIVER (PORT 2)
Driver Differential V_OUT (no load)
Driver Differential V_OUT (with load)
V_OD1
V_OD2
R = 50Ω (RS-422) (Figure 2)
R = 27Ω (RS-485) (Figure 2)
Full
-
Full
2
-
V_CC
V
2.3
-
V
Full
1.5
2
5
V
Change in Magnitude of Driver
Differential V_OUT for
Complementary Output States
V_OD3 R_D = 60Ω, R = 375Ω, V_CM = -7V to 12V (Figure 2) Full
1.5
-
5
V
V_OD R = 27Ω or 50Ω (Figure 2)
Full
-
0.01
0.2
V
Driver Common-Mode V_OUT
Change in Magnitude of Driver
Common-Mode V_OUT for
Complementary Output States
V_OC
V_OC
R = 27Ω or 50Ω (Figure 2)
R = 27Ω or 50Ω (Figure 2)
Full
-
-
3
V
Full
-
0.01
0.2
V
Driver Short-Circuit Current,
V_OUT = High or Low
I_OS
-7V ≤ (V_Y or V_Z) ≤ 12V (Note 12)
Full
35
-
250
mA
Driver Three-State Output Leakage
Current (Y, Z)
I_OZ
Outputs disabled,
V_CC = 0V or 3.6V
V_OUT = 12V Full
-
-
200
µA
V_OUT = -7V
Full
-200
-
-
µA
DC CHARACTERISTICS - RS-232 DRIVER (PORT 1)
Driver Output Voltage Swing
V_O
All T_OUTS loaded with 3kΩ to ground
Driver Output Short-Circuit Current
I_OS
V_OUT = 0V
DC CHARACTERISTICS - LOGIC PINS (i.e., DRIVER AND CONTROL INPUT PINS)
Full
±5
-
-
V
Full
-60
-
60
mA
Input High Voltage
Input Low Voltage
Input Current
V_IH
V_IL
I_IN1 Pins Without Pull ups or Pull downs
I_IN2 SLOW485, DE485, RE485, SHDN
Full
2.2
-
-
V
Full
-
-
0.8
V
Full
-2
-
2
µA
Full
-25
-
25
µA
Submit Document Feedback
6
FN8776.1
October 21, 2016