HSP50306 Datasheet, PDF (6/8 Pages) Intersil Corporation – Digital QPSK Demodulator

HSP50306
Absolute Maximum Ratings T_A = 25^oC
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +7.0V
Input, Output or I/O Voltage . . . . . . . . . . . GND -0.5V to V_CC +0.5V
Typical Derating Factor . . . . . . . . . . . . .4mA/MHz Increase in I_CCOP
ESD Classification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Class 1
Operating Conditions
Thermal Information
Thermal Resistance (Typical, Note 4)
θ_JA (^oC/W)
SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
100
Maximum Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . 150^oC
Maximum Storage Temperature Range . . . . . . . . . .-65^oC to 150^oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . . 300^oC
(SOIC - Lead Tips Only)
Operating Voltage Range . . . . . . . . . . . . . . . . . . . . . .4.75V to 5.25V
Operating Temperature Range . . . . . . . . . . . . . . . . . . . .0^oC to 70^oC
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTE:
4. θ_JA is measured with the component mounted on an evaluation PC board in free air.
DC Electrical Specifications V_CC = 5.0V ±5%, T_A = 0^o to 70^oC
PARAMETER
SYMBOL
TEST CONDITIONS
Power Supply Current
I_CCOP
V_CC = Max, CLK = 28.6MHz
(Notes 5, 6)
Standby Power Supply Current
I_CCSB
V_CC = Max, Outputs Not Loaded
Input Leakage Current
I_I
V_CC = Max, Input = 0V or V_CC
CMOS Output High (ADCLK, AGCOUT)
V_OHC
V_CC = Min, I_OH = -400µA
CMOS Output Low (ADCLK, AGCOUT)
V_OLC
V_CC = Min, I_OL = 2mA
Logical One Input Voltage
V_IH
V_CC = Max
Logical Zero Input Voltage
V_IL
V_CC = Min
Logical One Output Voltage
V_OH
I_OH = -400µA, V_CC = Min
Logical Zero Output Voltage
V_OL
I_OL = 2mA, V_CC = Min
Input Capacitance
Output Capacitance
C_IN
C_OUT
CLK = 1MHz
All measurements referenced to GND.
T_A = 25^oC, (Note 7)
NOTES:
5. Power supply current is proportional to frequency. Typical rating is 4mA/MHz.
6. Output load per test circuit and C_L = 40pF.
7. Not tested, but characterized at initial design and at major process/design changes.
MIN MAX UNITS
-
114
mA
-
500
µA
-10
10
µA
3.7
-
V
-
0.4
V
2.0
-
V
-
0.8
V
2.4
-
V
-
0.4
V
-
10
pF
-
10
pF
8-277