|
ISL78302A_14 Datasheet, PDF (5/11 Pages) Intersil Corporation – Dual LDO with Low Noise, Very High PSRR and Low IQ | |||
|
◁ |
ISL78302A
Electrical Specifications Unless otherwise noted, all parameters are guaranteed over the operational supply voltage and
temperature range of the device as follows: TA = -40°C to 105°C; VIN = (VO + 0.5V) to 6.5V with a minimum VIN of 2.3V; CIN = 1µF; CO = 1µF;
CBYP = 0.01µF; CPOR = 0.01µF. Boldface limits apply over the operating temperature range, -40°C to +105°C. (Continued) (Continued)
PARAMETER
SYMBOL
TEST CONDITIONS
MIN
MAX
(Note 6) TYP (Note 6) UNITS
Output Noise Voltage
IO = 100µA, VO = 1.5V, TA = +25°C, CBYP = 0.1µF
BW = 10Hz to 100kHz
30
µVRMS
DEVICE START-UP CHARACTERISTICS
Device Enable Time
tEN Time from assertion of the ENx pin to when the output voltage
reaches 95% of the VO (nom)
250 500
µs
LDO Soft-Start Ramp Rate
tSSR Slope of linear portion of LDO output voltage ramp during start-up
EN1, EN2 PIN CHARACTERISTICS
30 60 µs/V
Input Low Voltage
VIL
Input High Voltage
VIH
Input Leakage Current
IIL, IIH
Pin Capacitance
CPIN
POR1, POR2 PIN CHARACTERISTICS
Informative
-0.3
1.35
0.5
V
VIN + 0.3 V
0.1
µA
5
pF
POR1, POR2 Thresholds
POR1 Delay
POR2 Delay
POR1, POR2 Pin Output Low
Voltage
VPOR+
VPOR-
tP1LH
tP1HL
tP2LH
tP2HL
VOL
As a percentage of nominal output voltage
CPOR = 0.01µF
@ IOL = 1.0mA
91 94 97
%
87 90 93
%
0.5 2.0 3.2
ms
25
µs
100 200 300
ms
25
µs
0.2
V
POR1, POR2 Pin Internal Pull-Up
Resistance
RPOR
78 100 180
kâ¦
NOTES:
6. Compliance to datasheet limits is assured by one or more methods: production test, characterization and/or design.
7. VOx = 0.98*VOx(NOM); valid for VOx greater than 1.85V.
EN1
EN2
tEN
VPOR+
VO1
VO2
POR1
POR2
tP1LH
tP2LH
VPOR-
VPOR+
<tP1HL
<tP2HL
tP1HL
tP2HL
VPOR-
FIGURE 2. TIMING PARAMETER DEFINITION
5
FN7932.1
December 23, 2013
|
▷ |