DG411883 Datasheet, PDF (5/10 Pages) Intersil Corporation – Monolithic Quad SPST CMOS Analog Switches

Specifications DG411/883, DG412/883, DG413/883
TABLE 2. AC ELECTRICAL PERFORMANCE CHARACTERISTICS
Device Tested at: V+ = +15V, V- = -15V, V_L = 5V, GND = 0V, Unless Otherwise Specified
PARAMETERS
Turn ON Time
Turn OFF Time
SYMBOL
t_ON
CONDITIONS
C_L = 35pF, V_S = ±10V,
R_L = 300Ω
V+ = 12V, V- = 0V,
C_L = 35pF, V_S = +8V,
R_L = 300Ω
t_OFF
C_L = 35pF, V_S = ±10V,
R_L = 300Ω
V+ = 12V, V- = 0V,
C_L = 35pF, V_S = +8V,
R_L = 300Ω
GROUP A
SUBGROUP TEMPERATURE
9, 11
+25^oC, -55^oC
10
+125^oC
9, 11
+25^oC, -55^oC
10
+125^oC
9, 11
10
9, 11
10
+25^oC, -55^oC
+125^oC
+25^oC, -55^oC
+125^oC
LIMITS
MIN MAX UNITS
0
175 ns
0
240 ns
0
250 ns
0
400 ns
0
145 ns
0
160 ns
0
125 ns
0
140 ns
TABLE 3. ELECTRICAL PERFORMANCE CHARACTERISTICS (NOTE 1)
Device Tested at: V+ = +15V, V- = -15V, V_L = 5V, GND = 0V, Unless Otherwise Specified
PARAMETERS
SYMBOL
CONDITIONS
GROUP A
LIMITS
SUBGROUP TEMPERATURE MIN MAX UNITS
Charge Injection
Q
See Figure 2, V_G = 0V, R_G = 0Ω ,
9
T_A = +25^oC, C_L = 10nF
+25^oC
+25^oC
-100 +100 pC
pC
See Figure 2,
9
V_G = 6V, R_G = 0Ω , T_A = +25^oC
C_L = 10nF, V+ = 12V, V- = 0V
+25^oC
+25^oC
-100 +100 pC
pC
NOTES:
1. V_IN = Input Voltage to Perform Proper Function.
2. Signals on S_X, D_X or IN_X exceeding V+ or V- will be clamped by internal diodes. Limit forward diode current to maximum current ratings.
3. All leads soldered or welded to PC board.
4. Parameters listed in Table 3 are controlled via design or process and are not directly tested at final production. These parameters are lab
characterized upon initial design release or upon design changes. These parameters are guaranteed by characterization based upon
data from multiple production runs which reflect lot to lot and within lot variation.
TABLE 4. ELECTRICAL TEST REQUIREMENTS
MIL-STD-883 TEST REQUIREMENTS
SUBGROUPS (SEE TABLES 1 AND 2)
Interim Electrical Parameters (Pre Burn-In)
1
Final Electrical Test Parameters
1 (Note 1), 2, 3, 9, 10, 11
Group A Test Requirements
1, 2, 3, 9, 10, 11
Groups C and D Endpoints
1
NOTE:
1. PDA applies to Subgroup 1 only.
Spec Number 512043
5