DG408_06 Datasheet, PDF (5/17 Pages) Intersil Corporation – Single 8-Channel/Differential 4-Channel, CMOS Analog Multiplexers

DG408, DG409
Electrical Specifications Test Conditions: V+ = +15V, V- = -15V, V_AL = 0.8V, V_AH = 2.4V, Unless Otherwise Specified (Continued)
PARAMETER
TEST CONDITIONS
TEMP (°C)
(NOTE 5)
MIN
(NOTE 6)
TYP
(NOTE 5)
MAX
UNITS
Drain OFF Leakage Current, I_D(OFF) V_EN = 0V, V_D = ±10V,
DG408
V_S = +10V
25
-1
-
1
nA
Full
-20
-
20
nA
DG409
25
-1
-
1
nA
Full
-10
-
10
nA
Drain ON Leakage Current, I_D(ON)
V_S = V_D = ±10V (Note 7)
DG408
25
-1
-
1
nA
Full
-20
-
20
nA
DG409
25
-1
-
1
nA
Full
-10
-
10
nA
POWER SUPPLY CHARACTERISTICS
Positive Supply Current, I+
Negative Supply Current, I-
V_EN = 0V, V_A = 0V (Standby)
Full
-
10
75
µA
Full
-75
1
-
µA
Positive Supply Current, I+
V_EN = 2.4V, V_A = 0V
(Enabled)
25
-
0.2
0.5
mA
Full
-
-
2
mA
Negative Supply Current, I-
Full
-500
-
-
µA
Electrical Specifications Single Supply Test Conditions: V+ = 12V, V- = 0V, V_AL = 0.8V, V_AH = 2.4V,
Unless Otherwise Specified
PARAMETER
TEST
CONDITION
TEMP (°C)
(NOTE 5)
MIN
(NOTE 6)
TYP
(NOTE 5)
MAX
UNITS
DYNAMIC CHARACTERISTICS
Switching Time of Multiplexer, t_TRANS V_S1 = 8V, V_S8 = 0V, V_IN = 2.4V
25
Enable Turn-ON Time, t_ON(EN)
V_INH = 2.4V, V_INL = 0V,
25
Enable Turn-OFF Time, t_OFF(EN)
V_S1 = 5V
25
Charge Injection, Q
C_L = 10nF, V_GEN = 0V,
25
R_GEN = 0Ω
ANALOG SWITCH CHARACTERISTICS
-
180
-
ns
-
180
-
ns
-
120
-
ns
-
5
-
pC
Analog Signal Range, V_ANALOG
Full
0
-
12
V
Drain-Source ON-Resistance,
r_DS(ON)
V_D = 3V, 10V, I_S = -1mA
(Note 7)
25
-
90
-
Ω
NOTES:
5. The algebraic convention whereby the most negative value is a minimum and the most positive a maximum, is used in this data sheet.
6. Typical values are for DESIGN AID ONLY, not guaranteed nor production tested.
7. Sequence each switch ON.
8. ∆r_DS(ON) = r_DS(ON) (Max) - r_DS(ON) (Min).
9. Worst case isolation occurs on channel 4 due to proximity to the drain pin.
5
FN3283.8
June 13, 2006