 English |
|
|
|
|
|
|
|
| DG408_06 Datasheet, PDF (4/17 Pages) Intersil Corporation – Single 8-Channel/Differential 4-Channel, CMOS Analog Multiplexers | |||
| |||
| ◁ |
DG408, DG409
Absolute Maximum Ratings
V+ to V- . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44.0V
GND to V-. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25V
Digital Inputs, VS, VD (Note 3). . . . . .(V-) -2V to (V+) + 2V or 20mA,
Whichever Occurs First
Continuous Current (Any Terminal) . . . . . . . . . . . . . . . . . . . . . 30mA
Peak Current, S or D (Pulsed 1ms, 10% Duty Cycle Max) . . 100mA
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . -40°C to 85°C
Thermal Information
Thermal Resistance (Typical, Note 4)
θJA (°C/W)
PDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
90
SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
110
TSSOP Package . . . . . . . . . . . . . . . . . . . . . . . . . . .
150
Maximum Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . 150°C
Maximum Storage Temperature Range . . . . . . . . . . -65°C to 125°C
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . . 300°C
(SOIC and TSSOP - Lead Tips Only)
CAUTION: Stresses above those listed in âAbsolute Maximum Ratingsâ may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
3. Signals on SX, DX, EN or AX exceeding V+ or V- are clamped by internal diodes. Limit diode current to maximum current ratings.
4. θJA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications Test Conditions: V+ = +15V, V- = -15V, VAL = 0.8V, VAH = 2.4V, Unless Otherwise Specified
PARAMETER
TEST CONDITIONS
TEMP (°C)
(NOTE 5)
MIN
(NOTE 6)
TYP
(NOTE 5)
MAX
DYNAMIC CHARACTERISTICS
Transition Time, tTRANS
Break-Before-Make Interval, tOPEN
Enable Turn-ON Time, tON(EN)
(See Figure 1)
(See Figure 3)
(See Figure 2)
Full
-
160
250
25
10
-
-
25
-
115
150
Full
-
-
225
Enable Turn-OFF Time, tOFF(EN)
Charge Injection, Q
OFF Isolation
(See Figure 2)
CL = 10nF, VS = 0V
VEN = 0V, RL = 1kâ¦,
f = 100kHz (Note 9)
Full
-
105
150
25
-
20
-
25
-
-75
-
Logic Input Capacitance, CIN
Source OFF Capacitance, CS(OFF)
f = 1MHz
VEN = 0V, VS = 0V,
f = 1MHz
25
-
8
-
25
-
3
-
Drain OFF Capacitance, CD(OFF)
DG408
VEN = 0V, VD = 0V,
f = 1MHz
25
-
26
-
DG409
25
-
14
-
Drain ON Capacitance, CD(ON)
VEN = 3V, VD = 0V,
DG408
f = 1MHz, VA = 0V or 3V
25
-
37
-
DG409
25
-
25
-
DIGITAL INPUT CHARACTERISTICS
Logic Input Current,
Input Voltage High, IAH
VA = 2.4V, 15V
Logic Input Current,
Input Voltage Low, IAL
VEN = 0V, 2.4V,
VA = 0V
ANALOG SWITCH CHARACTERISTICS
Full
-10
-
10
Full
-10
-
10
Analog Signal Range, VANALOG
Drain-Source ON Resistance,
rDS(ON)
VD = ±10V, IS = -10mA
(Note 7)
Full
-15
-
15
25
-
40
100
Full
-
-
125
rDS(ON) Matching Between Channels, VD = 10V, -10V (Note 8)
25
-
ârDS(ON)
-
15
Source OFF Leakage Current, IS(OFF) VEN = 0V, VS = ±10V,
VD = +10V
25
-0.5
-
0.5
Full
-5
-
5
UNITS
ns
ns
ns
ns
ns
pC
dB
pF
pF
pF
pF
pF
pF
µA
µA
V
â¦
â¦
â¦
nA
nA
4
FN3283.8
June 13, 2006
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese