ISL32610E Datasheet, PDF (4/12 Pages) Intersil Corporation – 16.5kV ESD Protected, 1.8V, Micro Power, 125°C, 1/8 Unit Load, RS-485/RS-422 Differential Receivers

ISL32610E, ISL32611E, ISL32612E
Absolute Maximum Ratings
V_CC to Ground . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7V
Input Voltages
RE, RE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 7V
A, B . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -8V to +12.5V
Output Voltages
RO. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to (V_CC +0.3V)
ESD Rating . . . . . . . . . . . . . . See “Electrical Specifications” Table page 5
Latch-up (per JESD78, Level 2, Class A) . . . . . . . . . . . . . . . . . . . . . +125°C
Thermal Information
Thermal Resistance (Typical)
θ_JA (°C/W) θ_JC (°C/W)
5 Ld SOT-23 Package (Note 6, 7) . . . . . . . 190
120
6 Ld SOT-23 Package (Note 6, 7) . . . . . . . 177
120
Maximum Junction Temperature (Plastic Package) . . . . . . . . . . . +150°C
Storage Temperature Range. . . . . . . . . . . . . . . . . . . . . . . -65°C to +150°C
Pb-Free Reflow Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
Recommended Operating Conditions
Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -40°C to +125°C
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.8V to 3.3V
Common Mode Input Voltage
V_CC = 1.8V . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -2V to +2V
V_CC = 3.3V . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -7V to +12V
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product
reliability and result in failures not covered by warranty.
NOTES:
6. θ_JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
7. For θ_JC, the “case temp” location is taken at the package top center.
(
Electrical Specifications Test Conditions: V_CC = 1.8V; Unless Otherwise Specified. Typicals are at V_CC = 1.8V, T_A = +25°C. Boldface
limits apply over the operating temperature range, -40°C to +125°C. (Note 9)
PARAMETER
SYMBOL
TEST CONDITIONS
TEMP MIN
MAX
(°C) (Note 8) TYP (Note 8) UNITS
DC CHARACTERISTICS
Logic Input High Voltage (Note 12)
Logic Input Low Voltage (Note 12)
Logic Input Current (Note 12)
Input Current (A, B) (Note 11)
Receiver Differential Threshold
Voltage
Receiver Input Hysteresis
Receiver Output High Voltage
Receiver Output Low Voltage
Three-State (High Impedance)
Receiver Output Current (Note 12)
V_IH
V_IL
I_IN1
I_IN2
V_TH
ΔV_TH
V_OH
V_OL
I_OZR
RE, RE
RE, RE
RE, RE
V_CC = 0V or 1.8V
V_CC = 0V or 3.6V
-2V ≤ V_CM ≤ 2V
-7V ≤ V_CM ≤ 12V
V_CM = 0V
I_O = -1mA, V_ID = 200mV
I_O = 2mA, V_ID = -200mV
0V ≤ V_O ≤ V_CC
V_CC = 1.8V
3V ≤ V_CC ≤ 3.6V
V_CC = 1.8V
3V ≤ V_CC ≤ 3.6V
V_CC = 1.8V
V_CC ≤ 3.6V
V_IN = 2V
V_IN = -2V
V_IN = 12V
V_IN = -7V
V_CC = 1.8V
3V ≤ V_CC ≤ 3.6V
V_CC = 1.8V
3V ≤ V_CC ≤ 3.6V
Full 1.2
-
Full
2
-
Full
-
-
Full
-
-
Full
-6
-
Full -12
-
Full
-
-
Full -60
-
Full
-
-
Full -100
-
Full -0.2
-
Full -0.2
-
Full
-
70
Full
-
70
Full V_CC - 0.4
-
Full
-
-
Full
-1
-
-
V
-
V
0.45 V
0.8
V
6
µA
12 µA
60 µA
-
µA
125 µA
-
µA
0.2
V
0.2
V
-
mV
-
mV
-
V
0.4
V
1
µA
Receiver Short-Circuit Current
No-Load Supply Current
Shutdown Supply Current
(Notes 10, 12)
I_OSR
I_CC
I_SHDN
0V ≤ V_O ≤ V_CC
RE = 0V or RE = V_CC
V_CC = 1.8V
3V ≤ V_CC ≤ 3.6V
ISL32611, RE = V_CC, V_CC ≥ 1.8V
ISL32612, RE = 0V
V_CC = 1.8V
V_CC ≤ 3.6V
Full
-
Full
-
Full
-
Full
-
Full
-
Full
-
-
30 mA
85
110 µA
-
135 µA
-
2
µA
-
7
µA
-
14 µA
4
FN7869.0
October 21, 2011