ISL3259E Datasheet, PDF (4/15 Pages) Intersil Corporation – ±15kV ESD Protected, 100Mbps, 5V, PROFIBUS®, Full Fail-safe RS-485/RS-422 Transceivers

ISL3259E
Absolute Maximum Ratings
V_CC to GND. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7V
Input Voltages
DI, DE, RE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 7V
Input/Output Voltages
A/Y, B/Z . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -9V to +13V
RO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to (V_CC +0.3V)
Short Circuit Duration
Y, Z . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Continuous
ESD Rating . . . . . . . . . . . . . . . . . . . . . . . . . See Specification Table
Thermal Information
Thermal Resistance (Typical)
θ_JA (°C/W)
8 Ld MSOP Package (Note 3) . . . . . . . . . . . . . . . . .
140
10 Ld DFN Package (Note 4). . . . . . . . . . . . . . . . . .
75
Maximum Junction Temperature (Plastic Package) . . . . . . +150°C
Maximum Storage Temperature Range . . . . . . . . . .-65°C to +150°C
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . .-40°C to +85°C
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTE:
3. θ_JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
4. θ_JA is measured in free air with the component mounted on a high effective thermal conductivity test board with “direct attach” features. See
Tech Brief TB379.
Electrical Specifications Test Conditions: V_CC = 4.75V to 5.25V; Unless Otherwise Specified. Typicals are at V_CC = 5V, T_A = +25°C,
(Note 5).
PARAMETER
SYMBOL
TEST CONDITIONS
TEMP MIN
MAX
(°C) (Note 14) TYP (Note 14) UNITS
DC CHARACTERISTICS
Driver Differential V_OUT
Change in Magnitude of Driver
Differential V_OUT for
Complementary Output States
V_OD
ΔV_OD
No Load
R_L = 100Ω (RS-422) (Figure 1A)
R_L = 54Ω (RS-485) (Figure 1A)
R_L = 60Ω, -7V ≤ V_CM ≤ 12V (Figure 1B)
R_L = 54Ω or 100Ω (Figure 1A)
Full
-
-
V_CC
Full
2.6
3.4
-
V
Full
2.1
2.8
V_CC
V
Full
1.9
2.7
-
V
Full
-
0.01
0.2
V
Driver Common-Mode V_OUT
Change in Magnitude of Driver
Common-Mode V_OUT for
Complementary Output States
V_OC
ΔV_OC
R_L = 54Ω or 100Ω (Figure 1A)
R_L = 54Ω or 100Ω (Figure 1A)
Full
-
2
3
V
Full
-
0.01
0.2
V
Logic Input High Voltage
V_IH DI, DE, RE
Full
2
-
-
V
Logic Input Low Voltage
V_IL DI, DE, RE
Full
-
-
0.8
V
Logic Input Current
I_IN1 DI = DE = RE = 0V or V_CC
Full
-2
-
2
µA
Input Current (A/Y, B/Z)
I_IN2 DE = 0V, V_CC = 0V or V_IN = 12V
5.25V
V_IN = -7V
Full
-
-
220
µA
Full
-160
-
-
µA
Driver Short-Circuit Current,
V_O = High or Low
I_OSD1 DE = V_CC, -7V ≤ V_Y or V_Z ≤ 12V (Note 7)
Full
-
-
±250
mA
Differential Capacitance
C_D A/Y to B/Z
25
-
9
-
pF
Receiver Differential Threshold
Voltage
V_TH -7V ≤ V_CM ≤ 12V
Full
-200
-
-50
mV
Receiver Input Hysteresis
Receiver Output High Voltage
Receiver Output Low Voltage
Receiver Output Low Current
Three-State (High Impedance)
Receiver Output Current
ΔV_TH
V_OH
V_OL
I_OL
I_OZR
V_CM = 0V
I_O = -8mA, V_ID = -50mV
I_O = +10mA, V_ID = -200mV
V_OL = 1V, V_ID = -200mV
0.4V ≤ V_O ≤ 2.4V
25
-
28
-
mV
Full V_CC - 0.5
-
Full
-
-
-
V
0.4
V
Full
25
40
-
mA
Full
-1
0.015
1
µA
4
FN6587.0
November 13, 2007