HA456_06 Datasheet, PDF (4/13 Pages) Intersil Corporation – 120MHz, Low Power, 8x8 Video Crosspoint Switch

HA456
Absolute Maximum Ratings
Supply Voltage (V+ to V-). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12V
Positive Supply Voltage (V+) Referred to AGND . . . . . . . . . . . . . 6V
Negative Supply Voltage (V-) Referred to AGND. . . . . . . . . . . . -6V
DGND Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AGND ±1V
Analog Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .±V_SUPPLY
Digital Input Voltage . . . . . . . . . . . . . . (V+ + 0.3V) to (DGND - 0.3V)
ESD Rating
Human Body Model (Per MIL-STD-883 Method 3015.7). . . . 1.5kV
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA (°C/W)
PLCC Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
47
Moisture Sensitivity (see Technical Brief TB363)
PLCC Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Level 1
Maximum Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . 150°C
Maximum Storage Temperature Range . . . . . . . . . . . -65°C to 150°C
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . . 300°C
(Lead Tips Only)
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0°C to 70°C
Supply Voltage Range (Typical). . . . . . . . . . . . . . . . . . . ±4.5V to ±5.5V
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTE:
1. θ_JA is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
Electrical Specifications
PARAMETER
V_SUPPLY = ±5V, AGND = DGND = 0V, R_L = 400Ω (Note 2), Unless Otherwise Specified.
TEST CONDITIONS
(NOTE 3)
TEST TEMP
LEVEL (°C) MIN TYP
Voltage Gain
V_IN = -1.5V to +1.5V, Worst Case
A
Switch Configuration
A
25 0.992 0.996
Full 0.99 0.995
Channel-to-Channel Gain Mismatch
A
25
- 0.001
A
Full
- 0.001
Supply Current
All Outputs Enabled, R_L = Open,
A
V_IN = 0V,
Total for All V+ (3) or V- (2) Pins
A
25
-
68
Full
-
71
Disabled Supply Current
All Outputs Disabled, R_L = Open,
A
Total for All V+ (3) or V- (2) Pins
A
25
-
47
Full
-
47
Input Voltage Range
A
Full
±2
±2.5
Analog Input Current
Input Noise (R_S = 75Ω)
V_IN = 0V
DC to 40MHz
≥ 10kHz
A
Full
-
1.6
B
25
-
0.15
B
25
-
22
Analog Input Resistance
DC
C
25
-
4
Analog Input Capacitance (Input
Connected to One Output or All Outputs,
Note 6)
B
25
-
3.2
Output Offset Voltage
V_IN = 0V, Worst Case Switch
Configuration
A
25
-18 -6.5
A
Full -20 -7.5
Channel-to-Channel Offset Voltage
Mismatch
A
25
-
2
A
Full
-
4
Offset Voltage Drift
B
Full
-
20
Output Voltage Swing
V_IN = ±2.5V
A
25 ±2.2 ±2.48
A
Full ±2.1 ±2.47
Output Resistance
Enabled, DC
B
25
-
0.25
Output Leakage Current
(Including D1/SER OUT)
All Outputs Disabled,
V_OUT = 2.5V
A
25
-
0.2
A
Full
-
1
MAX
1.00
1.00
0.004
0.005
80
83
65
67
-
12
-
-
-
-
5
6
11
13
-
-
-
-
5
10
UNITS
V/V
V/V
mA
mA
V
μA
mV_RMS
nV/√Hz
MΩ
pF
mV
mV
μV/°C
V
V
Ω
μA
μA
4
FN4153.5
August 14, 2006