ISL54207 Datasheet, PDF (3/14 Pages) Intersil Corporation – Low Voltage, Dual SPDT, USB/CVBS/ Audio Switches, with Negative Signal Capability

ISL54207
Absolute Maximum Ratings
VDD to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3 to 6.0V
Input Voltages
NCx, NOx(Note 2) . . . . . . . . . . . . . . . . . . . - 2V to ((V_DD) + 0.3V)
VBUS (Note 2). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -2V to 5.5V
CTRL (Note 2) . . . . . . . . . . . . . . . . . . . . . . -0.3 to ((V_DD) + 0.3V)
Output Voltages
COMx (Note 2) . . . . . . . . . . . . . . . . . . . . . . -2V to ((V_DD) + 0.3V)
Continuous Current (NCx, COMx) . . . . . . . . . . . . . . . . . . . ±150mA
Peak Current (NCx, COMx)
(Pulsed 1ms, 10% Duty Cycle, Max). . . . . . . . . . . . . . . . ±300mA
Continuous Current (NOx) . . . . . . . . . . . . . . . . . . . . . . . . . . ±40mA
Peak Current (NOx)
(Pulsed 1ms, 10% Duty Cycle, Max) . . . . . . . . . . . . . . . . ±100mA
ESD Rating:
HBM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >7kV
MM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >450V
CDM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >2kV
Thermal Information
Thermal Resistance (Typical, Note 3)
θ_JA (°C/W)
10 Ld μTQFN Package . . . . . . . . . . . . . . . . . . . . . . . 130
10 Ld 3x3 TDFN Package. . . . . . . . . . . . . . . . . . . . .
110
Maximum Junction Temperature (Plastic Package) . . . . . . . +150°C
Maximum Storage Temperature Range. . . . . . . . . . . . -65°C to +150°C
Operating Conditions
Temperature Range
ISL54207IRUZ and ISL54207IRZ. . . . . . . . . . . . . . . -40°C to +85°C
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
2. Signals on NOx, NCx, COMx, CTRL, VBUS exceeding V_DD or GND by specified amount are clamped. Limit current to maximum current ratings.
3. θ_JA is measured with the component mounted on a high effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
Electrical Specifications - 2.7V to 3.6V Supply Test Conditions: V_DD = +3.0V, GND = 0V, V_BUSH = 3.8V, V_BUSL = 3.2V,
V_CTRLH = 1.4V, V_CTRLL = 0.5V, (Notes 4, 6), unless otherwise specified.
PARAMETER
TEST CONDITIONS
TEMP (NOTE 5)
(°C)
MIN
ANALOG SWITCH CHARACTERISTICS
Audio/Video Switches (NC1, NC2)
Analog Signal Range, V_ANALOG
ON Resistance, r_ON
V_DD = 3.0V, V_BUS = float, CTRL = 1.4V
V_DD = 3.0V, V_BUS = float, CTRL = 1.4V,
I_COMx = 100mA, V_NCx = -0.85V to 0.85V,
(See Figure 3)
Full
-1.5
25
-
Full
-
r_ON Matching Between Channels, V_DD = 3.0V, V_BUS = float, CTRL = 1.4V, I_COMx = 100mA, 25
-
Δr_ON
V_NCx = Voltage at max r_ON over signal range of -0.85V to
0.85V, (Note 8)
Full
-
r_ON Flatness, r_FLAT(ON)
V_DD = 3.0V, V_BUS = float, CTRL = 1.4V,
I_COMx = 100mA, V_NCx = -0.85V to 0.85V, (Note 7)
25
-
Full
-
Discharge Pull-Down Resistance, V_DD = 3.6V, V_BUS = float, CTRL = 1.4V, V_COM- or
25
-
R_NC1, R_NC2
V_COM+ = -0.85V, 0.85V, V_NCx = -0.85V, 0.85V,
V_NOx = floating, Measure current through the discharge
pull-down resistor and calculate resistance value.
USB Switches (NO1, NO2)
Analog Signal Range, V_ANALOG
ON Resistance, r_ON
V_DD = 3.0V, V_BUS = 5.0V, CTRL = 0V or 3V
V_DD = 3.6V, V_BUS = 4.4V, CTRL = 0V or 3.6V,
I_COMx = 40mA, V_NOx = 0V to 400mV
(See Figure 4)
Full
0
25
-
Full
-
r_ON Matching Between Channels,
ΔR_ON
V_DD = 3.6V, V_BUS = 4.4V, CTRL = 0V or 3.6V,
I_COMx = 40mA, V_NOx = Voltage at max r_ON,
(Note 8)
25
-
Full
-
r_ON Flatness, r_FLAT(ON)
V_DD = 3.6V, V_BUS = 4.4V, CTRL = 0V or 3.6V,
I_COMx = 40mA, V_NOx = 0V to 400mV, (Note 7)
25
-
Full
-
TYP
-
2.65
-
0.02
-
0.03
-
50
-
4.6
-
0.06
-
0.4
-
(NOTE 5)
MAX UNITS
1.5
V
4
Ω
5.5
Ω
0.13
Ω
0.16
Ω
0.05
Ω
0.07
Ω
-
kΩ
V_DD
V
5
Ω
6.5
Ω
0.5
Ω
0.55
Ω
0.6
Ω
1.0
Ω
3
FN6403.0
December 5, 2006