ICM7217_01 Datasheet, PDF (3/20 Pages) Intersil Corporation – 4-Digit LED Display, Programmable Up/Down Counter

ICM7217
Absolute Maximum Ratings
Supply Voltage (V_DD - V_SS) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6V
Input Voltage (Any Terminal) . . . . . . . . (V_SS - 0.3V) to (V_DD + 0.3V)
(Note 1)
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . -25^oC to 85^oC
Thermal Information
Thermal Resistance (Typical, Note 2)
θ_JA (^oC/W) θ_JC (^oC/W)
CERDIP Package . . . . . . . . . . . . . . . .
55
14
PDIP Package . . . . . . . . . . . . . . . . . . .
55
N/A
Maximum Junction Temperature
PDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150^oC
CERDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 175^oC
Maximum Storage Temperature Range . . . . . . . . . .-65^oC to 150^oC
Maximum Lead Temperature (Soldering, 10s) . . . . . . . . . . . . 300^oC
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. Due to the SCR structure inherent in the CMOS process used to fabricate these devices, connecting any terminal to a voltage greater
than V_DD or less than V_SS may cause destructive device latchup. For this reason it is recommended that the power supply to the device
be established before any inputs are applied and that in multiple systems the supply to the ICM7217 be turned on first.
2. θ_JA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications V_DD = 5V, V_SS = 0V, T_A = 25^oC, Display Diode Drop 1 .7V, Unless Otherwise Specified
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX
Supply Current
Display Off, LC, DC, UP/DN,
-
(Lowest Power Mode), IDD (7217) ST, RS, BCD I/O Floating or at V_DD (Note 1)
350
500
Supply Current, OPERATING, I_OP Common Anode, Display On, all “8’s”
140
200
-
Supply Current, OPERATING, I_OP Common Cathode, Display On, all “8’s”
50
100
-
V_SUPPLY, V_DD
4.5
5
5.5
Digit Driver Output Current, I_DIG Common Anode, V_OUT = V_DD - 2.0V
140
200
-
SEGment Driver
Output Current, ISEG
Common Anode, V_OUT = +1.5V
20
35
-
Digit Driver, Output Current, I_DIG
SEGment Driver
Output Current, ISEG
Common Cathode, V_OUT = +1.0V
Common Cathode V_OUT = V_DD - 2V
-50
-75
-
-9
-12.5
-
ST, RS, UP/DN Input
Pullup Current, IP
V_IN = V_DD - 2V (Note 1)
5
25
-
3 Level Input Impendance, ZIN
40
-
350
BCD I/O Input, High Voltage
VBIH
ICM7217 Common Anode (Note 2)
ICM7217 Common Cathode (Note 2)
1.5
-
-
4.40
-
-
BCD I/O Input, Low Voltage
VBIL
ICM7217 Common Anode (Note 2)
ICM7217 Common Cathode (Note 2)
-
-
0.60
-
-
3.2V
BCD I/O Input, Pullup Current
ICM7217 Common Cathode V_IN = V_DD - 2V
5
25
-
IBPU
(Note 2)
BCD I/O Input
Pulldown Current, IBPD
ICM7217 Common Anode V_IN = +2V (Note 2)
5
25
-
BCD I/O, ZERO, EQUAL Outputs I_OH = -100µA
Output High Voltage, VOH
3.5
-
-
BCD I/O, CARRY/BORROW
ZERO, EQUAL Outputs
Output Low Voltage, V_OL
Count Input Frequency, f_IN
I_OL = 1.6mA
-20^oC to 70^oC
Guaranteed
-
-
0.4
-
5
-
0
-
2
Count Input Threshold, VTH
(Note 3)
-
2
-
Count Input Hysteresis, VHYS
(Note 3)
-
0.5
-
Count Input LO, VCIL
-
-
0.40
Count Input HI, VCIH
3.5
-
-
UNIT
µA
mA
mA
V
mA_PEAK
mA_PEAK
mA_PEAK
mA_PEAK
µA
kΩ
V
V
V
V
µA
µA
V
V
MHz
MHz
V
V
V
V
3