English
Language : 

SP600 Datasheet, PDF (2/7 Pages) Intersil Corporation – Half Bridge 500VDC Driver
SP600
Absolute Maximum Ratings Full Temperature Range, All Thermal Information
Voltage Referenced to VSS Unless Otherwise Noted. Note 1, Note 2.
Low Voltage Power Supply, VBIAS (Note 1) . . . . . . . . . . . . . . 18VDC
Floating Low Voltage Boot Strap . . . . . . . . . . . . . . . . . . . . . . 18VDC
Power Supply to Phase, VBS
Low Voltage Signal Pins
Fault, ITRIPSEL, VDD, TRIPL, CL1, G2L . . . -0.5VDC to VDD +0.5
G1L, D1L, VDF, TOP, BOT
CL2, TRIPU, G1U, G2U, D1U to Phase. . . . -0.5VDC to VBS +0.5
High Voltage Pins
Phase, VPHASE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500VDC
(VBS, VOUT, TRIPU, CL2, G2U and D1U: 0V-18V Higher Than
Phase)
Dynamic High Voltage Rating Phase, . . . . . . . . . . . . . 10,000V/µs
DVPHASE/DT
Thermal Resistance
Plastic DIP Package . . . . . . . . . . . . . . . . . . . . . . . .
75θoJCA/W
Maximum Package Power Dissipation at TA = +85oC, PO
Plastic DIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500mW
Operating Ambient Temperature Range, TA
Storage Temperature Range, TS. . . . . . . . .
.
.
.
.
.
.
.
.
.
.
. .-25oC to +85oC
.-40oC to +150oC
Lead Temperature (Soldering 10s) . . . . . . . . . . . . . . . . . . . . +265oC
NOTES:
1. Care must be taken in the application of VBIAS as not to impose high peak dissipation demands on a relatively small metallized noise dropping resistor (RND).
Prolonged high peak currents may result if +15VDC is applied abruptly and/or if the local bypass capacitor CDD is large. It is suggested that CDD be ≤ 10MFD.
If it is desirable to switch the 15VDC source or if a CDD is larger, additional series impedance may be required.
2. Consult factory for additional package offerings.
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
Electrical Specifications
(VBIAS = 15V, Pulsed <300ms), Unless Otherwise Noted, All Parameters Referenced to
VSS Except TRIPU, CL2, G1U, D1U, and VBS Referenced to PHASE. DF: VDF to VBS,
CF: VBS to PHASE
PARAMETER
DC CHARACTERISTICS
Input Current (5V < VTOP, VBOT, VTRIPSEL < 15V)
IBIAS Quiescent Current (All Inputs Low)
IBIAS Quiescent Current
(VOUT ≥ VBIAS, and All Inputs Low)
IBS Quiescent Current Bootstrap Supply
TOP Threshold Level
BOTTOM Threshold Level
Current TRIPSELECT Threshold Level
Trip Lower and Upper Comparator Threshold
Level - Normal (ITRIPSEL = VSS)
Trip Lower and Upper Comparator Threshold
Level - Boost (ITRIPSEL = VDD) % of Measured
VTRIP L/UN
Under Voltage Lockout Thresholds (VDD and VBS)
Phase Out of Status Voltage Threshold (PHASE)
SYMBOL
IIN
IBIASL
IBIASH
IBS
VTOP
VBOT
VTRIPSEL
VTRIP L/UN
VTRIP L/UB
VLOCK
VOSVT
TEMP
+25oC
-40oC to +85oC
+25oC
-40oC to +85oC
+25oC
-40oC to +85oC
+25oC
-40oC to +85oC
+25oC
-40oC to +85oC
+25oC
-40oC to +85oC
+25oC
-40oC to +85oC
+25oC
-40oC to +85oC
+25oC
-40oC to +85oC
+25oC
-40oC to +85oC
+25oC
-40oC to +85oC
MIN
-
-
-
-
-
-
-
-
7
6.95
7
6.9
7
6.95
90
90
110
109
9
9.7
5
4.7
TYP
20
30
1.7
1.7
1.7
1.7
875
900
8
8
8
8
8
8
105
105
130
130
10
10.5
7
7
MAX
30
33
2.05
2.1
2.05
2.1
1000
1060
9
9.1
9
9.1
9
9.1
125
127
150
152
11.5
11.8
9
9.6
UNITS
µA
µA
mA
mA
mA
mA
µA
µA
V
V
V
V
V
V
mV
mV
%
%
V
V
V
V
2