HA4244 Datasheet, PDF (2/6 Pages) Intersil Corporation – 480MHz, 1 x 1 Video Crosspoint Switch with Synchronous Enable

HA4244
Absolute Maximum Ratings
Voltage Between V+ and V-. . . . . . . . . . . . . . . . . . . . . . . . . . . . 12V
Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . V_SUPPLY
Digital Input Current (Note 2) . . . . . . . . . . . . . . . . . . . . . . . . . ±25mA
Output Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20mA
Operating Conditions
Temperature Range. . . . . . . . . . . . . . . . . . . . . . . . . . . . 0^oC to 70^oC
Thermal Information
Thermal Resistance (Typical, Note 1)
θ_JA (^oC/W)
SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
158
Maximum Junction Temperature (Plastic Package) . . . . . . . 150^oC
Maximum Storage Temperature Range . . . . . . . . . -65^oC to 150^oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300^oC
(SOIC - Lead Tips Only)
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. θ_JA is measured with the component mounted on an evaluation PC board in free air.
2. If an input signal is applied before the supplies are powered up, the input current must be limited to this maximum value.
Electrical Specifications V_SUPPLY = ±5V, R_L = 10kΩ, V_EN = 2.0V, Unless Otherwise Specified
PARAMETER
TEST CONDITIONS
TEMP.
(^oC)
MIN
HA4244
TYP
MAX
UNITS
DC SUPPLY CHARACTERISTICS
Supply Voltage
Full
±4.5
±5.0
±5.5
V
Supply Current
(V_OUT = 0V)
ANALOG DC CHARACTERISTICS
V_EN = 2.0V
V_EN = 2.0V
V_EN = 0.8V
V_EN = 0.8V
25, 70
-
0
-
25, 70
-
0
-
10.5
13
mA
-
14.5
mA
-
275
µA
-
325
µA
Output Voltage Swing without Clipping V_OUT = V_IN ± V_IO ± 20mV
25, 70
±2.7
±2.8
-
V
0
±2.4
±2.5
-
V
Output Current
Full
15
20
-
mA
Input Bias Current
Full
-
30
50
µA
Output Offset Voltage
Output Offset Voltage Drift (Note 3)
25
-10
-
10
mV
Full
-
25
50
µV/^oC
SWITCHING CHARACTERISTICS
Turn-On Time
25
-
160
-
ns
Turn-Off Time
25
-
320
-
ns
DIGITAL DC CHARACTERISTICS
Input Logic High Voltage
Full
2
-
-
V
Input Logic Low Voltage
Full
-
-
0.8
V
EN Input Current
CLK Input Current
EN Setup Time to CLK Rising Edge
V_EN = 0 to 4V
V_CLK = 0 to 4V
Full
-2
-
2
µA
Full
-10
-
10
µA
Full
-
25
-
ns
EN Hold Time after CLKRising Edge
Full
-
10
-
ns
2