ISL29034_14 Datasheet, PDF (15/15 Pages) Intersil Corporation – Integrated Digital Light Sensor

Package Outline Drawing
L4.1.5x1.3
4 LD 1.5X1.3 OPTICAL DUAL FLAT NO-LEAD (ODFN)
Rev 5, 4/12
6
PIN 1
INDEX AREA
1.50
A
B
1.30
(4X) 0.10
TOP VIEW
ISL29034
(0.55)
6
PIN #1
INDEX AREA
4
0.50
3
3X 0 . 40 ± 0 . 10
BOTTOM VIEW
1
0.25 ±0.07 4
2
0.10 M C A B
1
(0.50)
2
(0.75)
(0.55)
(3x0.60)
4
3 ^{(4 x 0.25)}
0.70 ±0.05
SIDE VIEW
SEE DETAIL "X"
0.10 C
BASE PLANE
SEATING PLANE
C
0.08 C
(1.30)
TYPICAL RECOMMENDED LAND PATTERN
C
0 . 2 REF
5
0 . 00 MIN.
0 . 05 MAX.
DETAIL "X"
NOTES:
1. Dimensions are in millimeters.
Dimensions in ( ) for Reference Only.
2. Dimensioning and tolerancing conform to AMSE Y14.5m-1994.
3. Unless otherwise specified, tolerance : Decimal ± 0.05
4. Dimension applies to the metallized terminal and is measured
between 0.18mm and 0.32mm from the terminal tip.
5. Tiebar shown (if present) is a non-functional feature.
6. The configuration of the pin #1 identifier is optional, but must be
located within the zone indicated. The pin #1 indentifier may be
either a mold or mark feature.
7. This package not defined by JEDEC, but MO-229 can be used as
a general reference.
Submit Document Feedback ₁₅
FN8370.1
April 9, 2014