ISL28118M Datasheet, PDF (15/22 Pages) Intersil Corporation – 40V Extended Temperature Range, Precision Single-Supply, Rail-to-Rail Output

ISL28118M
PD_MAX for each amplifier can be calculated using Equation 2:
PD_MAX
=
V_S × I_qMAX + (V_S
-
V_OUTMAX
)
×
V_{----O----U---T---M-----A---X--}
R_L
(EQ. 2)
where:
• PD_MAX = Maximum power dissipation of 1 amplifier
• V_S = Total supply voltage
• I_qMAX = Maximum quiescent supply current of one amplifier
• V_OUTMAX = Maximum output voltage swing of the application
• R_L = Load resistance
ISL28118M SPICE Model
Figure 50 shows the SPICE model schematic and Figure 51 shows
the net list for the SPICE model. The model is a simplified version
of the actual device and simulates important AC and DC
parameters. AC parameters incorporated into the model are: 1/f
and flatband noise voltage, slew rate, CMRR, and gain and phase.
The DC parameters are I_OS, total supply current, and output
voltage swing. The model uses typical parameters given in the
“Electrical Specifications” table beginning on page 3. The AVOL is
adjusted for 136dB with the dominant pole at 0.6Hz. The CMRR is
set at 120dB, f = 50kHz. The input stage models the actual device
to present an accurate AC representation. The model is configured
for an ambient temperature of +25°C.
Figures 52 through 66 show the characterization vs. simulation
results for the noise voltage, open loop gain phase, closed loop
gain vs. frequency, gain vs. frequency vs. RL, CMRR, large signal
10V step response, small signal 0.1V step, and output voltage
swing ±15V supplies.
LICENSE STATEMENT
The information in the SPICE model is protected under United
States copyright laws. Intersil Corporation hereby grants users of
this macro-model, hereto referred to as “Licensee”, a
nonexclusive, nontransferable licence to use this model, as long
as the Licensee abides by the terms of this agreement. Before
using this macro-model, the Licensee should read this license. If
the Licensee does not accept these terms, permission to use the
model is not granted.
The Licensee may not sell, loan, rent, or license the
macro-model, in whole, in part, or in modified form, to anyone
outside the Licensee’s company. The Licensee may modify the
macro-model to suit his/her specific applications, and the
Licensee may make copies of this macro-model for use within
their company only.
This macro-model is provided “AS IS, WHERE IS, AND WITH NO
WARRANTY OF ANY KIND EITHER EXPRESSED OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.”
In no event will Intersil be liable for special, collateral, incidental,
or consequential damages in connection with or arising out of
the use of this macro-model. Intersil reserves the right to make
changes to the product and the macro-model without prior
notice.
15
FN7858.0
May 11, 2011