ISL1208_06 Datasheet, PDF (15/21 Pages) Intersil Corporation – Low Power RTC with Battery Backed SRAM

ISL1208
receiver pulls the SDA line LOW to acknowledge the
reception of the eight bits of data (See Figure 13).
The ISL1208 responds with an ACK after recognition of a
START condition followed by a valid Identification Byte, and
once again after successful receipt of an Address Byte. The
ISL1208 also responds with an ACK after receiving a Data
Byte of a write operation. The master must respond with an
ACK after receiving a Data Byte of a read operation.
SCL
SDA
START
DATA
DATA
DATA
STABLE CHANGE STABLE
STOP
FIGURE 12. VALID DATA CHANGES, START, AND STOP CONDITIONS
SCL FROM
MASTER
1
SDA OUTPUT FROM
TRANSMITTER
8
9
HIGH IMPEDANCE
SDA OUTPUT FROM
RECEIVER
HIGH IMPEDANCE
START
ACK
FIGURE 13. ACKNOWLEDGE RESPONSE FROM RECEIVER
SIGNALS FROM
THE MASTER
SIGNAL AT SDA
SIGNALS FROM
THE ISL1208
WRITE
S
T
A ^{IDENTIFICATION}
R
BYTE
T
ADDRESS
BYTE
11011110 0000
A
A
C
C
K
K
DATA
BYTE
S
T
O
P
A
C
K
FIGURE 14. BYTE WRITE SEQUENCE
15
FN8085.5
August 23, 2006