HC5549_14 Datasheet, PDF (13/13 Pages) Intersil Corporation – Low Power SLIC with Battery Switch

HC5549
Pin Description
PLCC
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
SYMBOL
TIP
BGND
VBL
VBH
SW+
SW-
SWC
F2
F1
F0
E0
DET
ALM
AGND
BSEL
NC
POL
VRB
VRX
VTX
VFB
-IN
VCC
CDC
RTD
ILIM
RD
RING
DESCRIPTION
TIP power amplifier output.
Battery Ground - To be connected to zero potential. All loop current and longitudinal current flow from this ground.
Internally separate from AGND but it is recommended that it is connected to the same potential as AGND.
Low battery supply connection.
High battery supply connection.
Uncommitted switch positive terminal.
Uncommitted switch negative terminal.
Switch control input. This TTL compatible input controls the uncommitted switch, with a logic “0” enabling the switch and
logic “1” disabling the switch.
Mode control input - MSB. F2-F0 for the TTL compatible parallel control interface for controlling the various modes of
operation of the device.
Mode control input.
Mode control input.
Detector Output Selection Input. This TTL input controls the multiplexing of the SHD (E0=1) and GKD (E0 =0) comparator
outputs to the DET output based upon the state at the F2-F0 pins.
Detector Output - This TTL output provides hook status of the loop based upon the selected operating mode. The
detected output will either be switch hook, ground key or ring trip.
Thermal Shutdown Alarm. This pin signals the internal die temperature has exceeded safe operating temperature and
the device has been powered down automatically.
Analog ground reference. This pin should be externally connected to BGND.
Selects between high and low battery, with a logic “1” selecting the high battery and logic “0” the low battery.
This pin is a “no connect” and should remain floating proper device operation.
Capacitor connected to this pin sets the polarity reversal slew rate.
Ringing Bias Input - Analog input to offset Tip output towards ground while in Ringing Mode.
Analog Receive Voltage - 4-wire analog audio input voltage. AC couples to codec.
Transmit output voltage - Output of impedance matching amplifier, AC couples to codec.
Feedback voltage for impedance matching. This voltage is scaled to accomplish impedance matching.
Impedance matching amplifier summing node.
Positive voltage power supply.
DC Biasing Filter Capacitor - Connects between this pin and VCC.
Ring trip filter network.
Loop Current Limit programming resistor.
Switch hook detection threshold programming resistor.
RING power amplifier output.
All Intersil U.S. products are manufactured, assembled and tested utilizing ISO9000 quality systems.
Intersil Corporation’s quality certifications can be viewed at www.intersil.com/design/quality
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without
notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and
reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result
from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
13
FN4539.3