X9250_06 Datasheet, PDF (11/20 Pages) Intersil Corporation – Quad Digitally Controlled Potentiometers

X9250
ABSOLUTE MAXIMUM RATINGS
Temperature under bias ........................ -65 to +135°C
Storage temperature ............................. -65 to +150°C
Voltage on SCK, SCL or any address input
with respect to V_SS ................................. -1V to +7V
Voltage on V+ (referenced to V_SS)........................ 10V
Voltage on V- (referenced to V_SS)........................-10V
(V+) - (V-) .............................................................. 12V
Any V_H/R_H ..............................................................V+
Any V_L/R_L.................................................................V-
Lead temperature (soldering, 10s) .................. +300°C
I_W (10s) ............................................................±15mA
COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only; functional operation of the
device (at these or any other conditions above those
listed in the operational sections of this specification) is
not implied. Exposure to absolute maximum rating
conditions for extended periods may affect device
reliability.
RECOMMENDED OPERATING CONDITIONS
Temp
Commercial
Industrial
Min.
0°C
-40°C
Max.
+70°C
+85°C
Device
X9250
X9250-2.7
Supply Voltage (V_CC) Limits⁽⁴⁾
5V ±10%
2.7V to 5.5V
POTENTIOMETER CHARACTERISTICS (Over recommended operating conditions unless otherwise stated.)
Limits
Symbol
Parameter
Min. Typ. Max. Unit
Test Conditions
End to end resistance tolerance
±20
%
Power rating
50
mW +25°C, each pot
I_W
Wiper current
R_W
Wiper resistance
Vv+
Voltage on V+ pin
X9250
±7.5
mA
150
250
Ω
Wiper current = ± 1mA
+4.5
+5.5
V
X9250-2.7 +2.7
+5.5
Vv-
Voltage on V- pin
X9250
-5.5
-4.5
V
X9250-2.7 -5.5
-2.7
V_TERM Voltage on any V_H/R_H or V_L/R_L pin V-
Noise
Resolution ⁽⁴⁾
Absolute linearity ⁽¹⁾
Relative linearity ⁽²⁾
Temperature coefficient of R_TOTAL
Ratiometric Temperature
Coefficient
-120
0.6
±300
V+
±1
±0.6
±20
V
dBV
%
MI⁽³⁾
MI⁽³⁾
ppm/°C
ppm/°C
Ref: 1kHz
V_w(n)(actual) - V_{w(n)(expected)}
V_{w(n + 1 -} [V_{w(n) + MI}]
C_H/C_L/C_W Potentiometer Capacitances
10/10/25
pF
See Circuit #3
Notes: (1) Absolute linearity is utilized to determine actual wiper voltage versus expected voltage as determined by wiper position when used as a
potentiometer.
(2) Relative linearity is utilized to determine the actual change in voltage between two successive tap positions when used as a potentiom-
eter. It is a measure of the error in step size.
(3) MI = RTOT/255 or (V_H/R_H - V_L/R_L)/255, single pot
(4) Individual array resolutions.
11
FN8165.3
August 29, 2006