ISL6612B Datasheet, PDF (11/12 Pages) Intersil Corporation – Advanced Synchronous Rectified Buck MOSFET Drivers with Pre-POR OVP

ISL6612B, ISL6613B
Small Outline Exposed Pad Plastic Packages (EPSOIC)
N
INDEX
AREA
123
TOP VIEW
H
E
-B-
0.25(0.010) M B M
-A-
D
SEATING PLANE
A
L
h x 45^o
-C-
α
e
A1
C
B
0.10(0.004)
0.25(0.010) M C A M B S
SIDE VIEW
123
P1
N
P
BOTTOM VIEW
M8.15B
8 LEAD NARROW BODY SMALL OUTLINE EXPOSED PAD
PLASTIC PACKAGE
INCHES
MILLIMETERS
SYMBOL MIN
MAX
MIN
MAX NOTES
A
0.056 0.066 1.43
1.68
-
A1
0.001 0.005 0.03
0.13
-
B
0.0138 0.0192 0.35
0.49
9
C
0.0075 0.0098 0.19
0.25
-
D
0.189 0.196 4.80
4.98
3
E
0.150 0.157 3.31
3.39
4
e
0.050 BSC
1.27 BSC
-
H
0.230 0.244 5.84
6.20
-
h
0.010 0.016 0.25
0.41
5
L
0.016 0.035 0.41
0.64
6
N
8
8
7
α
0^o
8^o
0^o
8^o
-
P
-
0.094
-
2.387
11
P1
-
0.094
-
2.387
11
Rev. 2 11/03
NOTES:
1. Symbols are defined in the “MO Series Symbol List” in Section
2.2 of Publication Number 95.
2. Dimensioning and tolerancing per ANSI Y14.5M-1982.
3. Dimension “D” does not include mold flash, protrusions or gate
burrs. Mold flash, protrusion and gate burrs shall not exceed
0.15mm (0.006 inch) per side.
4. Dimension “E” does not include interlead flash or protrusions.
Interlead flash and protrusions shall not exceed 0.25mm (0.010
inch) per side.
5. The chamfer on the body is optional. If it is not present, a visual
index feature must be located within the crosshatched area.
6. “L” is the length of terminal for soldering to a substrate.
7. “N” is the number of terminal positions.
8. Terminal numbers are shown for reference only.
9. The lead width “B”, as measured 0.36mm (0.014 inch) or greater
above the seating plane, shall not exceed a maximum value of
0.61mm (0.024 inch).
10. Controlling dimension: MILLIMETER. Converted inch
dimensions are not necessarily exact.
11. Dimensions “P” and “P1” are thermal and/or electrical enhanced
variations. Values shown are maximum size of exposed pad
within lead count and body size.
11
FN9205.3
July 27, 2006