FMCE-0328 Datasheet, PDF (8/10 Pages) Interpoint Corporation Company – Attenuation to 60 db at 500 kHz, typical Operating temperature -55° to +125°C

Crane Aerospace & Electronics Power Solutions
FMCE-0328 EMI Input Filter
28 Volt Input – 3 Amp
BOTTOM VIEW CASE G3
Flanged cases: Designator "F" required in Case Option position of model number
Projection Weld
1.130 max. (28.70)
0.960 (24.38)
0.030 dia.
(0.76)
0.560 (14.22)
0.160 (4.06)
0.000
Squared corner and dot on top
of case indicate pin one.
1
2
3
5
4
2 x Dia 0.128 (3.25)
2 x R 0.130 (3.30)
(2.005 max (50.93))
Flange thickness: 0.047 (1.19)
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device. Solder pins
individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold compression glass seal.
Seal Hole: 0.080 ±0.002 (2.03 ±0.05)
Case G3, Rev C, 20091105
Please refer to the numerical dimensions for accuracy. All information is believed to
be accurate, but no responsibility is assumed for errors or omissions. Interpoint
reserves the right to make changes in products or specifications without notice.
Copyright © 1999-2009 Interpoint Corp. All rights reserved.
Figure 10: Case G3
www.interpoint.com
Page 8 of 10
FMCE-0328 Rev D - 20100413