FMSA-461 Datasheet, PDF (6/7 Pages) Interpoint Corporation Company – EMI INPUT FILTER 28 VOLT INPUT

CASES
BOTTOM VIEW CASE A1
FMSA EMI Filter and STF EMI Filter
Seam Seal Projection Weld
0.697
(17.70
0.397
(10.08)
0.097
(2.46)
0.000
Squared corner and dot on
top of case indicate pin one.
1
23
8
4
7
65
0.018 ± 0.002 dia.
(0.46 ± 0.05)
Seal hole: 0.056 ±0.002 (1.42 ±0.05)
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin
Case A1, Rev B, September 8, 2005
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2005 Interpoint Corp. All rights reserved.