FMSA-461 Datasheet, PDF (5/7 Pages) Interpoint Corporation Company – EMI INPUT FILTER 28 VOLT INPUT

CASES
CASE A MAXIMUM DIMENSIONS
BOTTOM VIEW
Dot on top of case
indicates pin one.
See cases A1 - A3 _{0.805 max}
for pin configurations. _(20.45)
0.980 max
(24.89)
Materials
Header Cases A1 and A2
Kovar/Nickel/Gold
Case A3
Kovar/Nickel)
Cover Kovar/Nickel
Pins
Kovar/Nickel/Gold,
matched glass seal
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.
Case A maximum dimensions, Rev B, September 23, 2005
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2005 Interpoint Corp. All rights reserved.