FMD28-461_14 Datasheet, PDF (6/8 Pages) Interpoint Corporation Company – EMI Input Filters 28 Volt input – 7 Amp

Crane Aerospace & Electronics Power Solutions
FMD28-461 EMI Input Filters
28 Volt input – 7 Amp
BOTTOM VIEW CASE J4
Solder Seal
Solder Tip-off
1.350 max. (34.29)
1.173 (29.79)
0.040 dia.
(1.02)
0.673
(17.09)
0.173
(4.39)
0.000
Squared corner and dot on top
of case indicate pin one.
1
2
5
4
3
2 x Dia 0.162 ±0.002
(4.11 ±0.05)
2 x R 0.170 (4.32)
(2.720 max (69.09))
Flange Thickness: 0.067 +0.005/-0.007 (1.70 +0.13/-0.8)
Weight: 55 grams typical
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device. Solder pins
individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold compression glass seal.
Gold plating of 50 - 150 microinches included in pin diameter.
Seal Hole: 0.091 ±0.002 (2.31 ±0.05)
Case J4 FMD, Rev G, 2014.02.05
Please refer to the numerical dimensions for accuracy.
Figure 6: Case J4 - FMD28-461
www.craneae.com/interpoint
Page 6 of 8
FMD28 Rev AA - 2014.02.06