HR120 Datasheet, PDF (5/6 Pages) Interpoint Corporation Company – –40°C to +85°C operation 50 V for up to 50 ms transient protection

DC/DC Converters
BOTTOM VIEW CASE E1
Projection Weld
1.130 max. (28.70)
0.960 (24.38)
0.030 dia.
(0.76)
Squared corner and dot on top
of case indicate pin one.
1
2345
0.160 (4.06)
8
0.000
7
6
hr120
series
12 Watt
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device. Solder pins
individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold compression glass seal.
Seal Hole: 0.080 ±0.002 (2.03 ±0.05)
Case E1, Rev D, 20090707
Please refer to the numerical dimensions for accuracy. All information is believed to
be accurate, but no responsibility is assumed for errors or omissions. Interpoint
reserves the right to make changes in products or specifications without notice.
Copyright © 1999-2009 Interpo_Fii_gnt_uC_reor₁p₁._:A_Cl_al _sri_egh_Et₁s reserved.
www.interpoint.com
Page 5 of 6
HR120 Rev C - 20090904