FME28-461_10 Datasheet, PDF (13/13 Pages) Interpoint Corporation Company – EMI Input Filters 28 Volt Input – 15 Amp

Crane Aerospace & Electronics Power Solutions
FME28-461 EMI Input Filters
28 Volt Input – 15 Amp
STANDARD AND /ES (NON-QML) AND /883 (CLASS H, QML)
PRODUCT ENVIRONMENTAL SCREENING
test perFOrmed
Pre-cap Inspection
Method 2017, 2032
Temperature Cycle (10 times)
Method 1010, Cond. C, -65°C to 150°C, ambient
Method 1010, Cond. B, -55°C to 125°C, ambient
Constant Acceleration
Method 2001, 3000 g
Method 2001, 500 g
Burn-in ²
Method 1015, 125°C case, typical
96 hours
160 hours
Final Electrical Test MIL-PRF-38534, Group A
Subgroups 1 through 6: -55°C, +25°C, +125°C case
Subgroups 1 and 4: +25°C case
Hermeticity Test
Fine Leak, Method 1014, Cond. A
Gross Leak, Method 1014, Cond. C
Gross Leak, Dip (1 x 10^-3)
Final visual inspection
Method 2009
125°C standard
nOn-Qml¹
yes
no
no
no
no
no
no
no
yes
no
no
yes
yes
125°C /es
nOn-Qml¹
yes
no
yes
no
yes
/883
Class h Qml
yes
yes
no
yes
no
yes
no
no
yes
no
yes
yes
no
yes
yes
yes
yes
no
no
yes
yes
Test methods are referenced to MIL-STD-883 as determined by MIL-PRF-38534.
Notes:
1. Standard and /ES, non-QML products, do not meet all of the requirements of MIL-PRF-38534.
2. Burn-in temperature designed to bring the case temperature to +125°C
FME28-461 EMI Input Filters FME28 Rev C - 20100226. This revision supersedes all previous releases. All technical information is believed to be accu-
rate, but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make changes in products or specifications without notice.
FME Series EMI Filters are a trademark of Interpoint. Copyright © 1999 - 2010 Interpoint Corporation. All rights reserved. www.interpoint.com
Page 13 of 13