IA88C00 Datasheet, PDF (31/80 Pages) InnovASIC, Inc – Microcontroller

IA88C00
Microcontroller
Data Sheet
As of Production Version -01
Figure 28b. Watch Dog Timer and Stop Mode Recovery Register (WDT/SMR) R230 Bank0
Bit
Initial Value
Read/Write
7
6
D7
D6
WDT time-out
0
0
R/W
R/W
5
D5
WDT
Enable
0
R/W
4
D4
WDT in
Stop
0
R/W
3
D3
WDT
Source
0
R/W
2
D2
SMR
On
0
R/W
1
0
D1
D0
SMR Source
0
0
R/W
R/W
This register controls the Watchdog Timer time-out and Stop recovery mode.
D1, D0 Stop Mode Recovery source select.
Bit D0 and D1 determine the Stop Mode Recovery source.
D1 D0
0
0
Recovery from RESET only
0
1
Recovery from P22 and RESET
1
0
Recovery from P32 and RESET
1
1
Recovery from any input for Port 4 and RESET
A hardware reset forces D0 and D1 to zero.
D2 Stop Recovery Edge
A 1 in this position indicates that a rising edge on any one of the recovery sources wakes the IA88C00
from Stop mode. A 0 indicates falling edge recovery. The reset value is 0.
D3 XTAL1/RC Select for WDT
When a zero is written to D3, the clock of the WDT is driven by the on-board RC oscillator. If D3 is set to
1, the WDT is driven by XTAL1. D3 has a zero reset value.
D4 WDT Enable During STOP or HALT
When this bit is set, WDT is enabled during STOP or HALT. In this case, recovery from STOP or HALT
should be performed before the selected time-out. A 0 in this bit location disables the WDT while the
IA88C00 is stopped or halted. A hardware reset forces this bit to a zero.
Copyright © 2005
Innovasic.com
Innovasic Semiconductor
ENG 21 0 050519-00
www.Innovasic
Page 31 of 80
1.888.824.4184