XC2361A_15 Datasheet, PDF (99/127 Pages) Infineon Technologies AG – 16/32-Bit Single-Chip Microcontroller with 32-Bit Performance

XC2361A, XC2363A, XC2364A, XC2365A
XC2000 Family / Base Line
Electrical Parameters
PLL frequency band selection
Different frequency bands can be selected for the VCO so that the operation of the PLL
can be adjusted to a wide range of input and output frequencies:
Table 24 System PLL Parameters
Parameter
Symbol
Min.
VCO output frequency
(VCO controlled)
f_VCO CC 50
100
VCO output frequency
(VCO free-running)
f_VCO CC 10
20
Values
Typ. Max.
−
110
−
160
−
40
−
80
Unit Note /
Test Condition
MHz
MHz
MHz
MHz
VCOSEL = 00_B
VCOSEL = 01_B
VCOSEL = 00_B
VCOSEL = 01_B
4.6.2.2 Wakeup Clock
When wakeup operation is selected (SYSCON0.CLKSEL = 00_B), the system clock is
derived from the low-frequency wakeup clock source:
f_SYS = f_WU.
In this mode, a basic functionality can be maintained without requiring an external clock
source and while minimizing the power consumption.
4.6.2.3 Selecting and Changing the Operating Frequency
When selecting a clock source and the clock generation method, the required
parameters must be carefully written to the respective bit fields, to avoid unintended
intermediate states.
Many applications change the frequency of the system clock (f_SYS) during operation in
order to optimize system performance and power consumption. Changing the operating
frequency also changes the switching currents, which influences the power supply.
To ensure proper operation of the on-chip EVRs while they generate the core voltage,
the operating frequency shall only be changed in certain steps. This prevents overshoots
and undershoots of the supply voltage.
To avoid the indicated problems, recommended sequences are provided which ensure
the intended operation of the clock system interacting with the power system.
Please refer to the Programmer’s Guide.
Data Sheet
99
V2.12, 2014-06