TLE4966-3K Datasheet, PDF (8/15 Pages) Infineon Technologies AG – High Sensitivity Automotive Hall Switch with direction detection

TLE4966-3K
Maximum Ratings
2.3
Application Circuit
It is recommended to use a series resistor R_S with 200Ω and a capacitor of C_S = 4.7nF for protection against
overvoltage and transients on the supply line. Pull-up resistors R_L are required for the output pins Q₁ and Q₂.
V_S
R_S
V_DD ^{RL RL}
CS
Q₁
Q₂
GND
Figure 3 Application Circuit
3
Maximum Ratings
Table 2 Absolute Maximum Ratings
T_j = -40°C to 150°C
Parameter
Symbol
Limit Values Unit
min.
max.
Supply voltage
V_DD
-18
18
V
V_S
-18
24
V_S
-18
26
Supply current
I_DD
-50
50
mA
through protection
device
Output voltage
V_Q
-0.7
18
V
-0.7
26
Continuous output I_Q
-50
50
mA
current
Junction
temperature
T_j
–
–
–
–
155
°C
165
175
195
Storage
temperature
T_S
-40
150
°C
Magnetic flux
B
–
density
unlimited mT
Conditions
for 1 h, R_S ≥ 200 Ω
for 5 min, R_S ≥ 200 Ω
for 5 min @ R_L = 1.2 kΩ (pull up resistor)
for 2000 h (not additive)
for 1000 h (not additive)
for 168 h (not additive)
for 3 x 1 h (additive)
Note: Stresses above the max. values listed here may cause permanent damage to the device. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability. Maximum ratings are
absolute ratings; exceeding only one of these values may cause irreversible damage to the integrated circuit.
Datasheet
8
Rev.1.0, 2010-09-20