TDA6230GP Datasheet, PDF (4/16 Pages) Infineon Technologies AG – Smart Octal Low-Side Switch Overtemperature Protection

Data Sheet TLE 6230 GP
Maximum Ratings for T_j = – 40°C to 150°C
Parameter
Supply Voltage
Continuous Drain Source Voltage (OUT1...OUT8)
Input Voltage, All Inputs and Data Lines
Load Dump Protection V_{Load Dump} = U_P+U_S; U_P=13.5 V
With Automotive Relay Load R_L = 70 Ω
R_I¹⁾⁼² Ω; t_d=400ms; IN = low or high
With R_L= 24 Ω; R_I=2 Ω; t_d=400ms; IN = high or low
Operating Temperature Range
Storage Temperature Range
Output Current per Channel (see el. characteristics)
Output Current per Channel @ T_A = 25°C
(All 8 Channels ON; Mounted on PCB ) ³⁾
Output Clamping Energy (single pulse)
I_D = 0.5 A
Power Dissipation (mounted on PCB) @ T_A = 25°C
Electrostatic Discharge Voltage (Human Body Model)
according to MIL STD 883D, method 3015.7 and EOS/ESD
assn. standard S5.1 – 1993
Output 1-8 Pins
All other Pins
DIN Humidity Category, DIN 40 040
IEC Climatic Category, DIN IEC 68-1
Thermal Resistance
junction - case
junction - ambient @ min. footprint
junction - ambient @ 6 cm² cooling area with heat pipes
Symbol Values
V_S
-0.3 ... + 7
V_DS
40
V_IN
V_Load
2₎
Dump
- 0.3 ... + 7
80
T_j
T_stg
I_D(lim)
I_D
52
- 40 ... + 150
- 55 ... + 150
I_{D(lim) min}
500
E_AS
50
P_tot
3.3
V_ESD
V_ESD
R_thJC
R_thJA
2000
2000
E
40/150/56
5
50
38
Unit
V
V
V
V
°C
A
mA
mJ
W
V
V
K/W
Minimum footprint
PCB with heat pipes,
backside 6 cm² cooling area
1₎
2₎
3₎
R_I=internal resistance of the load dump test pulse generator LD200
V_LoadDump is setup without DUT connected to the generator per ISO 7637-1 and DIN 40 839.
Output current rating so long as maximum junction temperature is not exceeded. At T_A = 125
°C
the
output
current has to be calculated using R_thJA according mounting conditions.
V2.3
Page 4
18. Nov. 2009