TLE7259-2GU Datasheet, PDF (26/31 Pages) Infineon Technologies AG – LIN Transceiver

TLE7259-2GU
Application Information
7.3
Master Termination
To achieve the required timings for the dominant to recessive transition of the bus signal an additional external
termination resistor of 1 kΩ is mandatory. It is recommended to place this resistor at the master node. To avoid
reverse currents from the bus line into the battery supply line it is recommended to place a diode in series with the
external pull-up. For small systems (low bus capacitance) the EMC performance of the system is supported by an
additional capacitor of at least 1 nF at the master node (see Figure 15 and Figure 16).The values for the Master
Termination resistor and the bus capacitances influence the performance of the LIN network. They depend on the
number of nodes inside the LIN network and on the parasitic cable capacitance of the LIN bus wiring.
7.4
External Capacitors
A capacitor of 10 µF at the supply voltage input V_S buffers the input voltage. In combination with the required
reverse polarity diode this prevents the device from a detecting power down conditions in case of negative
transients on the supply line (see Figure 15 and Figure 16).
The 100 nF capacitor close to the V_S pin of the TLE7259-2GU is required to get the best EMC performance.
Data Sheet
26
Rev. 1.1, 2008-07-14