English
Language : 

TLE6282G_08 Datasheet, PDF (2/16 Pages) Infineon Technologies AG – Dual Half Bridge Driver IC Compatible to very low ohmic normal
Data Sheet TLE6282G
Application Block Diagram – Injector / Valve Drive
Watchdog
Reset
TLE
I
4278G
Q
CQ
22µF
D
CD
47nF
R
10 Ω
CS
47µF
VS=12V
RQ
47 kΩ
WD
R
VCC
RQ
47 kΩ
µC
CS
1µF
VS
BH1
DH1
ER1
GH1
SH1
BH2
DH2
GH2
DT/
DIS
SH2
TLE6282G
DL1
GL1
IH1
IL1
DL2
IH2
GL2
IL2
GND
CB
220nF
Load 1
CB
220nF
RSCDL1
RSCDL2
Load 2
RSCDL3
RSCDL4
This application diagram shows the principle schematics of a typical injector / valve drive. Other
configurations are possible as well. Freewheeling diodes are not considered. The voltage divider
networks, e.g. R = 10 kΩ, across the two Low Side MOSFETs are an example as well; they allow
to increase the current limit threshold for Short Circuit protection SCD for the Low Side MOS-
FETs. As they pull down the Sources of the High Side MOSFETs (while the Low Side MOSFETs
are off), they allow to pre-charge the CBx capacitors during start-up (before the Driver IC gets en-
abled). The SCD current limit threshold can be increased for the High Side MOSFETs as well by
using voltage divider networks across the High Side MOSFETs. SCD can also be disabled (High
Side and / or Low Side MOSFETs).
Data Sheet
2
Rev 2.4 2008-03-18