SAK82C900 Datasheet, PDF (18/29 Pages) Infineon Technologies AG – Standalone TwinCAN Controller

82C900
Preliminary
DC Characteristics
Operating Conditions apply.
Table 4
DC Characteristics under Normal Operation Conditions
Parameter
Symbol Limit Values Unit Test Condition
min. max.
Input low voltage
(XTAL1)
V_IL
– 0.5 0.3 V_DD V –
Input high voltage
(XTAL1)
V_IH
0.7 V_DD V_DD + V –
0.5
Input low voltage
(other pins)
V_IL
– 0.5 0.2 V_DD V –
– 0.1
Input high voltage
(other pins)
V_IH
0.2 V_DD V_DD + V –
+ 0.9 0.5
Output low voltage ¹⁾
(P0..P7)
V_OLP
–
0.45 V I_OLP = 5 mA
Output high voltage ¹⁾
(P0..P7)
V_OHP
2.4
–
0.9 V_DD –
V I_OHP = -5 mA
V I_OHP = -0.5 mA
Output low voltage
(other pins)
V_OL
–
0.45 V I_OL = 2.4 mA
Output high voltage ²⁾
(other pins)
V_OH
2.4
–
0.9 V_DD –
V I_OH = -2.4 mA
V I_OH = -0.5 mA
Input leakage current
RESET inactive current ³⁾
RESET active current
I_OZ
I_RSTH ⁴⁾
I_RSTL ⁵⁾
–
–
-100
±500
-10
–
nA 0.45V < V_IN < V_DD
µA V_IN = V_IH
µA V_IN = V_IL
XTAL1 input current
Pin capacitance ⁶⁾
(digital inputs/outputs)
I_IL
–
C_IO
–
±20
µA 0 V < V_IN < V_DD
10
pF f = 1 MHz
T_A = 25 °C
1) _{The sum of | IOHP |, IOLP must not exceed 20mA.}
2) _{This specification is not valid for outputs which are switched to open drain mode. In this case the respective}
output will float and the voltage results from the external circuitry.
3) _{These parameters describe the RESET pull-up, which equals a resistance of ca. 50 to 250 KΩ.}
4) _{The maximum current may be drawn while the respective signal line remains inactive.}
5) _{The minimum current must be drawn in order to drive the respective signal line active.}
6) _{Not 100% tested, guaranteed by design characterization.}
Data Sheet
18
V 1.0D3, 2001-03