BGM15LA12 Datasheet, PDF (18/24 Pages) Infineon Technologies AG – Low-Band LNA Multiplexer Module

BGM15LA12
Table 13: Register Mapping – Continued from previous page
Register Register Name
Data Function
Description
Address
Bits
0x001C PM_TRIG
7:6 PWR_MODE
00: Normal operation
01: Default settings (STARTUP)
10: Low power (LOW POWER)
11: Reserved
5 TRIGGER_MASK_2
If this bit is set, trigger 2 is disabled.
When all triggers disabled, if writing to
a register that is associated to trigger
2, the data goes directly to the desti-
nation register.
4 TRIGGER_MASK_1
If this bit is set, trigger 1 is disabled.
When all triggers disabled, if writing to
a register that is associated to trigger
1, the data goes directly to the desti-
nation register.
3 TRIGGER_MASK_0
If this bit is set, trigger 0 is disabled.
When all triggers disabled, if writing to
a register that is associated to trigger
0, the data goes directly to the desti-
nation register.
2 TRIGGER_2
A write of a one to this bit loads trigger
2’s registers.
1 TRIGGER_1
A write of a one to this bit loads trigger
1’s registers.
0 TRIGGER_0
A write of a one to this bit loads trigger
0’s registers.
0x001F MAN_USID
7:6 SPARE
These are read-only bits that are re-
served and yield a value of 0b00 at
readback.
5:4 MANUFACTURER_ID [9:8] These bits are read-only. However,
during the programming of the USID,
a write command sequence is per-
formed on this register even though
the write does not change its value.
3:0 USID
Programmable USID. Performing a
write to this register using the de-
scribed programming sequences will
program the USID in devices support-
ing this feature. These bits store the
USID of the device.
0x001A RFFE_STATUS
7 SOFTWARE RESET
0: Normal operation
1: Software reset
6 COMMAND_FRAME_
Command sequence received with
PARITY_ERR
parity error - discard command.
5 COMMAND_LENGTH_ERR Command length error
4 ADDRESS_FRAME_
Address frame parity error = 1
PARITY_ERR
3 DATA_FRAME_
Data frame with parity error
PARITY_ERR
2 READ_UNUSED_REG
Read command to an invalid address
1 WRITE_UNUSED_REG
Write command to an invalid address
0 BID_GID_ERR
Read command with a BROAD-
CAST_ID or GROUP_SID
0x001B GROUP_SID
7:4 RESERVED
3:0 GROUP_SID
Group slave ID
Default
10
0
0
0
0
0
0
00
01
0001
0
0
0
0
0
0
0
0
0
0
Broadcast_ID Trigger R/W
Support
Support
Yes
No
R/W
No
No
No
No
No
No
Yes
No
Yes
No
R/W
Yes
No
No
No
R/W
No
No
R/W
No
No
R
No
No
R/W
Data Sheet
18
Revision 3.0 - 2015-07-24